Data lost after rejuvenation

Once LiPo batteries have been damaged, they cannot be rejuvenated.

Hi,

Please follow the steps below to reset the lenovo to factory settings
Note: All your data will be lost. So keep that in mind.
So take the backup of your data first in a separate HDD or flash drive.

1. Switch off the Computer
2. Press the power button and then immediately start tapping f11 key on the top of your keyboard.
3. You will hear a beep sound and then stop pressing it.
4. You will get the screen says windows is loading files. Wait untill it finishes.
5. Select the default language which is US and Click on next .
6. Enter your login credentials (username and password) if you use to login to the windows.
7. Then you will get the system Recovery Options screen where you need to select the last option "Lenovo Product Recovery"
8. Again preferred language will be English US and hit Next.
9. Accept the terms and conditions and hit next and then hit Yes on the warning.
10. Then it will start resetting the Lenovo Think pad to the factory default with no previous data. Same as when you purchased it.

If you have any query you can ask before restoring the Computer.
Hope this helps you. Reply if that fixes your issue.

Sukhiii

The rubber roller that is in the hopper (pick roller) needs to be replaced. Most likely all rollers in the printer need to be replaced. Contact TulsaBiz.net or MIdWestIDSolutions.com You can buy parts from them or send in for repair.

This could be caused either by the rollers slipping or by dirty rollers. You can try cleaning the printer (instructions here: http://www.office.xerox.com/userdoc/P840/P840man/840.38.html#42766). If that doesn't work you can try using a rubber rejuvenator product on the rollers. Over time the rollers get hard and the rejuvenator basically moisturizes it.

The picture tube emission is dropping causing the picture to become washed out, the rejuvenating process removes build up of crud from the guns exposing more emission material, this improves quality in the overall picture. But since the picture tube was done a week ago it suggests the guns have been stripped of their remaining material and the picture tube will get progressively worse over time.

Unfortunately it sounds like the crt or picture tube is failing. Even though some can be rejuvenated it will be costly getting crt replaced or rejuvenated.

Hello hellian82,

The problem is the arcing red tube, it can be replaced or rejuvenated by qualified TV technician. The arcing is the result of a spark gap being formed in the picture tube resulting in a short between the HV anode of the tube and ground. Replacement of the tube is preferred, but the tube can be rejuvenated using a CRT rejuvenator.

I hope this helps,

Thank you,

Shuttle83

http://www.electron-age-technologies-llc.com

When you insert a new stack of paper, don't forget to loosen the pages by flipping pages with your thumb on the upper and lower edges which loosens and separates the individual pages. Static electricity will also cause them to stick together. if this doesn't work, the rubber rollers that pickup the paper will wear out and get smooth and shiny, you can use rubber rejuvenator (Circuit City Sources) rejuvenate the rubber will fix that problem .do not use alcohol as it will eventually dry and crack the rubber. Good luck

If the picture is fuzzy (out of focus) it may have a focus adjustment on the flyback transformer. Possibly an adjustment available from the outside, through the back. Look for any markings on the plastic housing indicating Focus, Brightness etc.. You can use a small screwdriver through the labeled holes in the case to make adjustments.
If the picture is crisp, but faint or the colors seem washed out it may be the tube is at it's end of life or needs to be rejuvenated. TV shops can rejuvenate tubes but it's not cheap.

Charge via your computer - takes 3-4 hours