SP 350 Blue screen

Hello.
Try to reset the camea, and check if that can get rid of the Blue busy thing on your screen.

Try replacing the media card

From what I am told your CCD is damaged. I have the same problem with my Z812.

I think the problem you have is that the shutter speed is too fast. make the shutter speed slower and try taking photos.

well most likely something on the circuit board has burnt out that sends messages to the screen. if that is the problem, you might have to buy a new camera. proud to be part of your help
-brandon

Hi. Mine did the same thing one day. I took the memory card and batteries out and let it sit for a few minutes. I then replaced the batteries, but it said, "batteries empty." I then replaced the batteries with silver and blue energizers. It powered right up. I was afraid it was a gonner, but it's been fine since.

either the card takes a lot of time to write ur data or the battery isn't giving enough power

take card out and see if you still get the same message... it could be the card or in need of repair

Hello,
your answer to this problem is easy. First take the batteries out of the camera, then open the camera ( screws should be in the back) the screen should just pop out of the cover and there is a ribbon cable that connects the screen to the circut board. Gently un-hook that ribbon where it plugs in to the board there might be a slid lock to hold the ribbon in place, it should unlock when you pull the cable out (memorize what position the ribbon is before unplugging). Now the fun part, do the same thing to the other camera, (carefully). To install the new screen, plug the ribbon back into the slot and it should be snug, if not there is a lock on it, gently push it back away from the ribbon ( a little finger pressure). Now, simply put it back together the same exact way you took it apart and don't forget the batteries. Have fun taking pictures...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/stephen_171aeeebef53a898

Wow same here but mine is red I know its because of the plasma bulb is wearing out and for my fix is $1000 but I didn't do want to go on so I tried to change the color settings and tried RGB to all 0 and it became fine. Well at least you have a cool blue screen, mine is red.