Power indicator red temp light on - Hitachi CP-X250 Multimedia Projector

Vehicle information needed .

Warning Indicator

? When the "LAMP" indicator lights solid red, the projector

will automatically shut itself down.

? When the "TEMP" indicator lights solid red for about 60

seconds, it indicates the projector has been overheated. The

projector will automatically shut itself down.

Under normal conditions, the projector can be switched on

again after it has cooled down. If the problem persists, you

should contact your local dealer or our service center.

? When the "TEMP" indicator lights solid red, it indicates the

fan failed. Please contact your local dealer or our service
center.

sounds like the water pump isn't working ,so as coolant isn't being pumped around engine it boils away and the engine overheats, get this sorted out asap as this will very soon ruin your engine , cutting out when stopping is related

Hello,

In attempts to get your IN15 projector working, please try the steps below.

Disconnect AC power from the projector and wait for 10 seconds for supply to properly discharge.

While holding down the Menu, Select and Input buttons simultaneously, plug in the main AC power until

the LEDS stop flashing (approximately 7 seconds)

There are three temp sensor inside the projector and now your projector need full service but if the air filter becomes clogged with dust, the internal temperature of the projector will rise, the TEMP indicator will illuminate and the projector's power will turn off (the TEMP indicator will flash after the power is turned off) The air filter should be cleaned every 100 hours of use.
If you clean the filter with a vacuum cleaner to clean off any accumulated dust. then your projector working normally

Most fryers have what is called a hi limit. When the oil temp reaches a certain Max temp this switch opens the circuit and will not allow the unit to heat. On commercial fryers, the hi limit has a really small red plunger button. Push it in to reset.

sounds like the lamp faceplate is not screwed back in properly

Good Day;
Try this:

Symptom: All Front LED indicators are flashing in sequence: Power-->Temp-->Lamp-->Power......continuously
Cause: Replace Lamp . This symptom may happen all the time or it may be intermittent. It is normal if it occurrs from time to time, See OG under TV Front Indicators explanation notes.
Good Luck, big IRISH.

Your service manual on page 82 steps you through decoding the blinking
1) there are two lights on the front near the reciever of the remote signals (Temp indicator and Lamp Indicator)
2) If the Temp indicator is on then they recommend you contact a service center
3) If the Lamp indicator is on and the power light stays on (no blinking) then you need to replace the lamp. Otherwise it says to contact the service center.
4) Counting blinks with the lamp indicator (1 every 5sec - lamp will not light or is abnormal, 2 every 5sec - lamp voltage is abnormal, 3 every 5sec - lamp temp is too high, 4 every 5sec - other error)

Refer to owners manual ! Blinking indicates the type of fault that is occuring on all your tv sets. example : power light on red - indicator light beside it green but blinks rapidly for half a second rapidly then shuts off. This refers to a faulty lamp or a lamp that is near its expiration. Read your manuals if indicators refer to easy repair sweet, but if it says call tech then bummer...