TV is DEAD, NO Raster, NO Picture, NO SOUND, POWER IS OK, SIGNAL IS OK, THE POWER LIGHT FLASHES AND GOES OUT AFTER I PRESS THE POWER ON BUTTON, QUESTIONS- - DOES ANYONE HAVE A SCHEMTIC TO SHARE ? - WHAT COMMON FAULTS(COMPONETS)CAN CAUSE PROBLEM? THANKING YOU IN ADVANCE
Sounds like a lamp error.... either a defective or broken lamp within the LCD panel itself, or you have a bad inverter.
I took one in for repair with the same problem. Turned out to be a capacitor. (C431) near backlight transformers. Mylar 184 @ 250V. Replaced C407 also to prevent same problem.
[email protected]
465 views
Usually answered in minutes!
Have the same Sharp LC-15AV4U 15 in. LCD Television, it comes on with good picture and sound for about 4 seconds, then shuts off. Power button will repeat this cycle indefinitely.
Looking for a schematic or service manual or hint as to suspect component in the power supply.
Thanks!
I have the same problem but can't find the anwser
[email protected]
The TV just "Blanked" out. It will not turn on
Sounds like a lamp error.... either a defective or broken lamp within the LCD panel itself, or you have a bad inverter.
Same problem. How much should repair cost?
WHEN I TRY TO TURN ON MY LC-15AV4U IT WOULD NOT
COME ON. I CHECK THE CAPACITORS IN THE POWER SUPPLY AND THE CAPACITOR APPEAR TO BE GOOD THERE IS NO BULGE AT THE CAPACITOR .WHAT IS THE POSSIBLE CAUSE.
×