The starter makes a tik tik tiking sound

It's possible the "new starter" has a bad solenoid so the actual starter motor never gets enough "juice" to turn. I have come across this problem several times. You may also have a serious battery drain, so there was enough "juice" to make the solenoid to Tik but not enought to turn the starter motor itself. I'd check the battery again, or try a different battery. The battery connections may have enough corrosion to prevent proper recharge. The charging system may not be performing properly.

First check your oil. Hyndais also tic tic tic from the top of the motor but it is the noise of the fuel system. If you let it go dry on oil at one time you may now have bad lifters.

You probably need a new battery. Have a shop test your battery an replace it if it's bad.

make sure wires on selinoid are on ther right sides if that isnt it replace selinoide

Help please....I have Mazda Protege 2002...the car was driving good..and suddenly the car didn't start at all i changed the starter the battery is fine because when i start the car the lights comes on and the radio works. I don't know what is the problem is...when i start the car it makes noise of tik tik. Please help me????

Sounds like the starter is fine and the crankshaft broke get to wher you can see the flywheel and turn the engine with the belt drive and if the flywheel don't turn your done

Try trouble shooting by using another battery to start the vehicle. If it does not start, then the starter must have gone bad.

Rate this please.

is it a rappid clicking if so bad batt. if single click bad starter rappid click somtimes mean dirty cables or bad ground single click is bad starter could be silanoid or contacks

You can try a thicker oil. But it sounds like a valve lifter may be going bad. Try an additive to see if it makes any difference. May be that the pump did not pump the oil right away. Run the car for a while . See how it sounds.If the ticking gets worse it is probobly one of the lifters.

replaced turn signal flashers and muti switch turn signal still won't work Why?