Question about Braun Series 7 790 Pulsonic Shaver System 1 ea

1 Answer

What does the yellow light mean on a braun series 7 shaver?

The yellow light in the center of the power indicator and on the front of the saver comes on periodically, then shuts off after a while. What does it mean?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

It is a light to tell you to replace your cutter cassette and foil. It will reset after 7 shaves. It usually comes on after 18 months or the cutter is worn. Page 11 in your manual.

Posted on Jan 25, 2015

Ad

2 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Joseph Hoffmann

  • 1755 Answers

SOURCE: The base for my Braun 7 series won't charge the

Hi, also it could be the charger is bad replace it. There is nothing you can do with that. Good luck

Posted on Dec 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The air conditioner cools the room but it shuts of. The power light doesn't come on while unit is on. Can I replace the plug?


"The air conditioner cools the room but it shuts of." -- Temperature reached, but does not turn back on automatically? Stops short of reaching temperature? Shuts off for a period, but will come back on only to shut off again later?
Most importantly, how do you get it to turn on again?
"The power light doesn't come on while unit is on." -- If the unit is on and the power light is not, then the power light must not be operating (is burnt out).
Actual answer: "Can I replace the plug?" -- Of course you can.
What is causing you to feel that the plug needs replaced?
:o).

Jun 04, 2011 | Daewoo DWC-056CL Air Conditioner

1 Answer

Why is light blinking on on-off button?


The blinking light indicates that the printer is on power saver mode. The Power Saver Mode saves energy by lowering power consumption during extended periods of inactivity. However, if you try to print from your computer when the printer is on power saver mode, the printer should automatically wake up and prints the job. You can also manually wake it up by just pressing and releasing the power button. Thanks.

Nov 19, 2010 | Lexmark X2470 All-In-One InkJet Printer

1 Answer

Yellow light on back, we get nothing on screen at power up.


hi,
Well you have said that back panel indicator stays Yellow (Amber it should be). I assume you are mentioning the PSU indicator (Power Supply Unit). If the PSU indicator turned on it means that PSU has shut down due to an Internal Protection event and needs Service Attention. If you have configured ALOM it will be much easier to detect the error. They will be logged in syslog. It will generate an Automatic mail as well.
Its better to run Sun Management Center and Hardware Diagnostic Suite to detect, avoid and manage such situation.
However if the Front Bezel Indicator is on (Service Indicator - Yellow) means that a Problem is Detected and needs the Attention of a Service Personnel.
Its not possible to detect an error remotely but it should be a misconfiguration (during usage) or a hardware failure.
Have you been using it or is it the firs time? If so you haven't powered the system on in the proper manner.
Its better if you can read these two important publications. Link 1 Link 2 You will be able to see and identify what when wrong or what you have done wrong. You can use built in tools as well to detect errors during post.
Administration Guide is located here.
Please rate the answer if it helps you to overcome the issue. Feel free to contact again.
Thanks for using Fixya!

Jul 01, 2010 | Sun Fire V240 Server

2 Answers

My ps3 starts to turn on for 1 second. Yellow light flashes, system shuts off, and red light blinks. Help?


HI, this is an emergency shut down, due to overheating. the yellow light is an indicator of a previous overheating issue that has damaged the power unit.

unplug the unit and, let it sit for 10 minutes to cool. after the cool off, plug the unit into the wall socket once more and, power up. if it continues to shut down and, flash the red light, this will confirm a major fault within the power unit. Contact Sony for the replacement of the power unit in this case.

***NOTE(If the unit begins to play normally after the cool-down period, you will need to purchase a cooling device to prevent future overheating issues).

Jul 21, 2009 | Sony Playstation 3 (PS3) Console

1 Answer

Problem with my cruise control and ABS light on 03 Explorer


Anti-Lock Control —Vehicles Built After 03/2002 The 3-channel anti-lock brake system consists of the following components:
  • front wheel speed sensors
  • front wheel speed sensor rings
  • hydraulic control unit (HCU)
  • Anti-lock brake control module (ECU)
  • rear wheel speed sensor
  • rear wheel speed sensor rings
  • yellow anti-lock brake warning indicator
The 4-channel anti-lock brake system with traction control and stability assist system consists of the following components:
  • active brake booster with integral solenoid
  • brake booster release switch
  • front wheel speed sensors
  • front wheel speed sensor rings
  • hydraulic control unit (HCU)
  • stability assist module (ECU)
  • stability assist event indicator
  • lateral accelerometer
  • longitudinal accelerometer (4x4)
  • rear wheel speed sensors
  • rear wheel speed sensor rings
  • steering wheel position sensor
  • yaw rate sensor
  • yellow anti-lock brake warning indicator
  • brake pressure transducer
  • traction control switch
---------------------------------------------------------------------
I suspect the abs issue is causing the speed control not to work if it happened at the same time the cruise control stopped working. When the yellow ABS light comes on, it means the ABS is dactivated. You may have a faulty accelerometer which senses acceleration and yaw (side to side lean). I have not seen a bad one but you said it is sensitive to acceleration.
I would unplug it and see what happens. The connector should have a small tab to depress so you can pull the connector out.
Here is where it is:

Accelerometer Removal and Installation
  1. NOTE: The accelerometer is located under the center, rear passenger seat carpet. (I think you have to remove seat for access).
    Cut the carpeting along the perforations.
  1. Disconnect the electrical connector.
  1. Remove the nuts and remove the accelerometer.
cd31596.gif
Have dealer hook up tester and pull fault codes if you can't find an easy solution.
Some background info
  • A malfunction in the anti-lock brake system will cause the anti-lock brake control module to shut off or inhibit the system. However, normal power-assisted braking remains.
  • Malfunctions are indicated by the yellow ABS warning indicator in the instrument cluster.
  • The anti-lock brake system is self-monitoring. When the ignition switch is turned to the RUN position, the anti-lock brake control module will carry out a preliminary self-check on the anti-lock electrical system indicated by a three-second illumination of the yellow ABS warning indicator in the instrument cluster.
  • During vehicle operation, including normal and anti-lock braking, the anti-lock brake control module monitors all electrical anti-lock functions and some hydraulic operations.
  • Each time the vehicle is driven, as soon as vehicle speed reaches approximately 20 km/h (12mph), the anti-lock brake control module turns on the pump motor for approximately one-half second. At this time, a mechanical noise may be heard. This is a normal function of the self-check by the anti-lock brake control module.
  • Pedal pulsation coupled with noise while braking on loose gravel, bumps, wet or snowy roads is normal and indicates correct functioning of the anti-lock brake system.
  • Warning Lamp Indicator
    The anti-lock brake system (ABS) uses the yellow ABS warning indicator to alert the driver of a malfunctions in the ABS.
    The yellow ABS warning indicator will come on to warn the driver that the ABS has been turned off due to a symptom that exists in the ABS. Normal power assist braking remains but wheels can lock during a panic stop while the yellow ABS warning indicator is illuminated.

    -----------------------------------------
    Please report back, I am curious if that is what it is. Good luck

    Mar 03, 2009 | 2003 Ford Explorer

    2 Answers

    IBM X226 server


    i have two x-series server but in one server with one power cords it is showing green light but in case of another server it is comming yellow light.

    Nov 24, 2008 | IBM xSeries 226 Server

    2 Answers

    Printer problems


    All four lights flashing indicated a problem only a service center can repair.

    Press the Go button and a new set of indicators will appear.

    The yellow toner light only indicates a fuser unit failure.
    The yellow drum light only indicates a laser unit failure.
    The yellow toner light AND the red paper light indicates a main motor failure.
    The red paper light only indicates a PCB failure (Printed Circuit Board).

    The only thing you can do at this point is to actually UNPLUG the power cord for 24 hours and then retry or if that fails take it to a service center or better yet go pay the $89 for a new unit.



    Hope this helps.

    Dec 25, 2007 | Brother HL-2040 Laser Printer

    2 Answers

    Shuts down after power up 50ux53k bought new 1998


    Refer to owners manual will tell you what blinking light means. But at the front not at the back.

    Dec 16, 2007 | Hitachi UltraVision CineForm 55VG825 55"...

    Not finding what you are looking for?
    Braun Series 7 790 Pulsonic Shaver System 1 ea Logo

    Related Topics:

    11,820 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Braun Health & Beauty Experts

    shaveroutlet.com
    shaveroutlet.com

    Level 3 Expert

    1639 Answers

    T.Johns

    Level 1 Expert

    7 Answers

    bigcheapskat

    Level 1 Expert

    2 Answers

    Are you a Braun Health and Beauty Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...