Nuovo Simonelli VIP 2 group

These machines are nothing but trouble! Try disconnecting from the mains for 10 minutes.

AppiaII-Manual-2-3Gr.pdf - Nuova Simonelli

https://simonelliusa.com > images > AppiaII-Manu...
PDF
of the group 2 or 3 for at least 8 seconds until the keys stop flashing. If you hold down the key of the second group, after first entering the programming.

• 
  

  ProgramVip-Manual-All.pdf - Nuova Simonelli

  https://simonelliusa.com > images > ProgramVip-...
  PDF
  ENTER confirms this setting and passes on to the cup warmer stop time setting, which is carried out using the wv keys once the display has begun to flash. To ...

Top 8 Troubleshooting of Nuova Simonelli Espresso Machine

https://kitchensmom.com > nuova-simonelli-espresso-m...
Troubleshooting 1 - Stop Light Remain On All The Time? Troubleshooting 2 - Is The Touchpad Flashing Unwantedly? Troubleshooting 3 - Is Nuova Simonelli Inept To ...

Troubleshooting NS Appia II - CoffeeSnobs

https://coffeesnobs.com.au > forum > equipment > 467...
May 27, 2017 - Power off / on. Pump runs and then goes to a diag mode of sorts. That is... all lights on and flashing manual/stop on each group

is it leaking on the side of the portafilter or what you mean is the dose is short? if dose is short, you can calibrate by pressing the fifth button on that group about 5 sec. then it will blink. prepare you grind in the portafilter then put it in the group. brew with the appropriate button the manually stop at the right level or quantity in the cup. you can do this with all the doses you require. Now by pressing the fifth button again 5 sec. you can exit programming mode.

the pressure should be at 9
but whine increase the tempter its will work

You might have to use pipe cleaners to get those clean or use a small drill bit.

Press and hold the stop button then press the desired button you want to program at the same time to enter programming mode then press stop to desired quantity

Could be lack of water in the boiler, could be a faulty pressure stat or vent valve. Check the level probe first, then the vent valve and then the pressure stat. You can also use the manual fill to make sure water is getting to the boiler.

for 3000Watts, at 220 Volts = 13.63 Amps. = 16.13333 OHMS,

Normal you hold in the continuous flow button till all lights flash or stay on.
then you press the first button to program, once the right amount of coffee has come out press that button again.

Continue this with all buttons.

Please sign up to servicing program, we teach you how to service and maintain your machine. This will save you $$$ hundreds in service agent fees. We stock all parts.
Email me at [email protected]

Are you talking about the handle?
Fit the spring in the indentation in the handle cup (just below the rim).
Then firmly push the filter inside the spring(you may need to give it a slap with the palm of your hand).

It sounds like a heating element issue. Those elements look like a single unit but are actually made up of 2 or 3 independent heating coils - one may not be working. So, you're only getting 1/2 to 2/3 heating capacity, which isn't noticeable until the machine is under heavy steam load.