CST In light is flashing green

Power connection within the board is lose

I had the same problem. We watched a DVD, and the unit worked fine. We went out for ice cream, came back, and decided to watch a VHS. Instead of taking the VHS, the CST.IN light flashed and the unit cut off after a few seconds. We didn't have a VHS in the unit at the time. After cutting the unit back on several times without success, I looked online for solutions. One person said to hit 'eject' 5 times in a row, but that didn't work for my unit. Someone else said there was a lever inside near the power button that ejected the VHS, so I checked that out next. I washed and dryed my hands well, and used my finger to jiggle the white lever. Then I saw that the tray that the VHS sits on wasn't all the way forward, so I gently pulled and pushed it. I'm not sure which of the two actions worked, but my light is now a steady green and my unit is working fine now. I am so glad because we've had this unit for almost 10 years now, and I really didn't want to have to buy a new one! Good luck!

When i turn on my tv the light turns orange green for a few seconds and then turns red and flash's... What do i do?

make sure batteries are tight in unit ,making good connection there are many internal things that could be wrong no rotation could be bad drive motor broken belt bad pcb robotoolz now owned by bosch who owns cst-berger discontinued robotoolz lasers there is a guy who will give free estimate on repair A.P. Service & supplies 610-944 8030

Your TV should be repairable. In home service can be obtained by calling 1-888-237-8289 in the U.S. or 1-866-237-8289 in Canada.

Some of these sets if you unplug them---The green power light will blink for about 70 seconds before it stops--this is normal as the receiver unit in this set is booting up. Wait for the light to stop blinking and then the set should turn on. Some of these sets develop a problem where the light never stops blinking--usually the receiver is now bad--very expensive to get fixed.

I do this here for free so if this helps you give me a vote here.

SD TECH (San Diego)

When this set is first plugged in the LED will flash for 70 to 90 seconds and then stop. During this time the unit will not operate. This is the amount of time it takes for the Digital Module to boot up. If the blinking LED never stops the Digital module is not booting up and must be repaired. I have done quite a few of these repairs and the average repair cost has been between $250 and $300.

i just replace the lamp, and don't have any light coming from lens,starting green (after a few seconds,green become to flash), then turning on orange and lamp light flashing...please i need help, fan working perfect...i don't have a remote,is a problem, or not

Here's something that might also be useful. After you turn on the set, and get the regular red blinky lights, hold down the Device and Menu buttons together for about 5 seconds.
The Power light will start to flash in a two digit sequence.
please post your error code