- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I would suspect that there is something along the track that's blocking the printhead carrier from moving left. Do a visual inspection of the entire track area. Try ((very carefully - do not force)) moving the carrier by hand and check for a blockage.
If you don't find anything, try unplugging for a few minutes and then try again (powerline glitch?).
Sharp LED/LCD EEP cleared Step
Remove Mains Plug
Press On/Off Switch from LED/LCD Panel
Press Ch Down & Input Switch together and plug in mains cord
LED/LCD will start
"K" will appier on Screen
Press Ch Down & Vol Down from LED/LED Panel
1/9 Page will appier on Screen
Go to 9/10 page by pressing Up & Down arrow of remote
Select EEP Cleared
Press ok button from remote
On Screen dispay EEP running
Remove Mains Plug after complete EEP Run
Please describe the status of the LED indicator. No LED would indicate a failure of the power supply. I can help you with that.
Flashing red would indicate a fan/lamp problem. Some lamps fail prematurely before the lamp hours are up.
If it is the power supply, no lights at all, I can get you running again. These units have fragile power supplies that can burn out with the slightest power surge. A UPS goes a long way to save future headaches.
well, what you could try is unplugging the power source from the cable modem, and the router. wait about 1 minute. then plug everything back in and wait.
i remember having this problem as well, but i think the problem with me was that my wireless computer was too far away from the wireless router, not saying that your too far or not, but that what i had, so i just pitched the wireless adapter, and created an ethernet connection. just sharing my experience.