I have a Toshiba Printing adding machine. Model bc-1294PV The machine powers up and prints, but a few keys on the machine do not seem to work. The most important key = does not get a response. I took it apart and could not see any thing wrong with it. Any help would be appreciated. Dan
An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: toshiba printing caluclator
Hey Dan, try cleaning the rubber contact pads under the key button with a damp rag as well as the board it contacts with. Some machines have a carbon contact instead of a rubber one. Look closely and make sure the carbon is not scratched or worn off. If so, scrap it.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you must connect the machine with you're computer.you want the fax you must check the you're photocopy machine have a fax board.you want the scan & printing connect the photocopy machine to the computer.(network cable)
Swtch on with pause key depressed and wait for the power and online leds blinks and error led off.
To cahnge from thertransfer or direct printing mode depress feed and pause spontaneoulsy.
By depresing feed the self test is printed
try adding printer and browsing network for printer, it should see the host and printer and add using correct network path, if you don't see host computer "print server" then you aren't on correct network path
Ok, if the copier is connected to your pc through usb port, then your pc suppose can print to the copier. Run a test print. If cannot, then u need to check the usb cable, usb port. * Assume that the driver is ok.
Your machine is old analague and a few years old now.It should be no problem changing.If your exposure settings are out it may be drum wear but more often or not all mirrors needing good clean.
Off top of head....M/c off..hold down 0and 8 numerics and power on...AD or AJ on display.punch in 15 and press print..... should read 00 on display... punch in01 and press green print button..press 09 and m/c ready to go if not switch off and on.
If unhappy with auto expose or manual middle expose...0+5 power on...AD or AJ on display,punch in 0+1 then print key opens exposure....pressing 1 increases light each press,,,try poss.10 times and print after to load.. and 7 decreases light to darken then print to change value. 0+9 together will get m/c to ready please try, all the best.