When the battery was changed the 'stop watch' second hand is not in the 12 o'clock possition when i reset it.
how can i get it back to the correct possition?
An expert who has achieved level 2 by getting 100 points
MVP:
An expert that got 5 achievements.
Sniper:
An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.
Governor:
An expert whose answer got voted for 20 times.
Expert
51 Answers
Re: Kenneth Cole KC3081
If you pull the crown out to the #2 position,then push the start/stop pusheryou will move the sweep sec. hand up to the 12 o'clock position. push in crown.
Don
Hold the reset button and press the start/stop to go into the setting mode. Then press/hold the start/stop to adjust the second hand and the reset button for the 30-minute one. Then do the reset+start/stop combo again to return to normal mode. I found this out myself in 5 minutes. Cool watch :]
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
They all set pretty much the same. Here is the general walk through from the Cole site:
Press the lower left button on the Kenneth Cole digital watches to cycle through the various modes. Press it three times to get into time mode (the face should be blinking). Press the upper right-hand button to change the seconds. Press the lower right-hand button to select the minutes.
1.make sure your battery good condition.
2. make sure installed properly.
3. reset movement there is two whole on circuit board use stapler pin to connect both whole for one second remove pin
your watch display should show up .
If it is a new watch then have you still got the user manual?
I have seen some watch instructions detailing how to do want you want to do, so it might be a common problem.
If you cannot sort it out and have a Kenneth Cole dealer near you, then take it in and discuss it with them.
Their web site does not seem to have any instruction manuals for downloading , so I can't read the instructions for myself but if phone them on 1 800 KEN COLE (536-26530), then they may be able to help you.
Pull your time adjustment knob out 2 clicks. hold down the chronograph time reset button and then press the start stop button and it will move to the next second. keep doing it until it is back at the 12 o'clock position.
That's easy. You need to calibrate it. In normal time mode, pull the crown out all the way and then use the pushers to step it back to the zero position. When finished, push the crown back in. You can also calibrate the sub-dails in a similar fashion.
×