I am at a loss. my machine fills up with water then stalls.The rotating sprayers do not spray water and the machine code A08 appears. The machine then empties itself.
Any ideas as i am desperate as my wife will go out and buy another one,
It will start the program and them bring up the error code A08 I have tried to rock the machine backwards as advised, this still brings up the error message. is there anyway of resetting it manually. please help.I have the A08 error code come up.
It will start the program and them bring up the error code A08 I have tried to rock the machine backwards as advised, this still brings up the error message. is there anyway of resetting it manually. please help.
AnonymousApr 13, 2009
now showing ao9?
now showing ao9?
You can't post conmments that contain an email address.
Sounds like it has overflowed at some stage. Ensure the filter is cleared and then rock the dishwasher backwards. Any trapped water will drain out and the safety valve will reset. i had similar and this was what the indesit technician did.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
A08 is a problem of the mother board , i changed this and i paid 130.000 for a **** ten minutes of work but i didn't resolve the problem. i waiting for another mother board.
you may have a bad heating element..or temperature sensor the water temperture is not getting hot enough to let the dishwasher run. you my reset it and try running the water in the sink until it reaches hot ... then try stating the dishwasher...let me know if this helps
Error message A01 means -Acqua stop operated due to a leak or overfill. Check if there is still water in the machine after it stop pumping. In case you still have water - your problem is with the pump or with a blockage drain line.
If there is no water in the machin, it might be a water level sensor issue - stuck physically in the high level position or become defective.
Try to reduced the water presure and leveled it up by the water entrance tap to the machine, it might solve your problem.
Goog luck !!
I have the A08 error code come up.
It will start the program and them bring up the error code A08 I have tried to rock the machine backwards as advised, this still brings up the error message. is there anyway of resetting it manually. please help.
now showing ao9?
×