Won't to change oil in Northstar 5500 watt generator, what type oil?

Stator is contacting the rotor, did you replace both bearings? remove the stator and look for damage on the stator and rotor laminates

Check the oil filter.

Code 32 is a low cranking speed sense. You didn't mention a Spec # which would help. You say batteries are ok, but the generator is not getting enough cranking amps or voltage to maintain the control properly. Check, battery voltage, wiring, any in line isolation solenoids, check generator solenoid, also make sure there is no mechanical binding on the generator, a good way to do that is remove the spark plugs DISCONNECT THE BATTERY to prevent starting, underneath where the air intake is under the alternator is a plastic plug, remove that and you can put a socket I believe 3/4" up onto the alternator shaft and rotate the engine, if it tuns freely there is no binding, if you feel it is hard to move, check the drive train, belts, pulleys underneath (A lot of work, best to take to a dealer if it is mechanically bound)

most of this generators have a shut off for low oil, so check your oil level to see if this is the problem

Depends on markings, oil range may b slotted lines between 2 vertical lines or 2 dots, or even the letter F.

I am just closing this out. Asker has manual.
Kelly

Hello, ushicks/me hillybilly. One question how old is the fuel in then generator tank,Hey. If it has a fuel filter replace it. Modern gasoline is junk fuel and after a few months it looses some chemical proprieties. GB...stewbison

I have the same Gen. An it dont have an oil filter

sounds like the carb should be pulled off and cleaned.Make sure to clean the jets and needle valve

Is the Output switch in the "ON" position...the switch is normally on the Outlet manel