Element FLX-2610 Red standby LED is lit, but will not turn on

http://www.retrevo.com/support/Element-FLX-1910-TVs-manual/id/4540dj093/t/2/

Unplug it leave it unplugged for about 10mins. replug it in and turn it on. If that doesnt work. Your going to most likely need to change the fuse for the power current. IF your not sure how to do this find expert repair services near you. It is cheaper to buy a new tv unless you try to do it yourself and end up damaging more

the only way it is to replace motherboard of it
you can not make it by your self cause it
need to be programmed

i m sorry

This just happened to me. I unplugged the power cable from the set, plugged it back in, and it worked just fine.

you can unplug the power cord and drench the power and after go ahead and plug in back the TV and try to start it

Have you tried using the power button on the TV instead of using the remote?

This could be a stress or overheating issue on the TV. Try to power cycle the TV by unplugging the power cord from the wall outlet and leave it disconnected for about 30 minutes, then turn it back on.

If same problem occur, then it's the power supply board that have gone bad. For power supply board problem, It would be best to contact the manufacturer or a repair tech for second opinion.

Good luck and have a great day!

Just because fuses are intact does not mean it is not damaged. Sometimes a small spike of power does not blow a fuse but damages Transformer windings Before the fuse! If there are no lights picture or sound think powersupply transformer primary.

UNPLUG AND TAKE OFF BACK ,,CHECK THE FUSE

TAKE OFF THE BACK AFTER U UNPLUG IT ,,CHECK THE FUSE

I had a similar problem and it was caused by my cable box being in scart 1 as soon as I changed over to scart 2 the problems went away,