Question about Sony KDF-E60A20 60 in. LCD HDTV

3 Answers

KDF-E60A20 Red Light Flashing 6x

My tv will not turn on - the power button is blinking red six times in a row and then stops.

Posted by steve dem on

  • 5 more comments 
  • Anonymous Nov 25, 2007

    my tv have the same problem after 2 years from now , tv on 12 hours straight then it turn off automatically. I though the lamp is bad, ordered new lamp still doesn't work. do some research. i see many people have thermal fuse is bad. can any one show me how to fix it, or buy thermal fuse at. here is my tv model: sony grand wega 60inch projection KDF-E60A20 . please reply me at [email protected]. thank you very much.

  • Anonymous Dec 17, 2007

    same problem 6x blink red

  • Scroggs Feb 27, 2008

    KDF-E60E20 same issue 6 blinking red light pattern out of no where. Found some research matching the fuse suggestion but no info on how to actually fix the problem. Please help!

  • moise681 Feb 29, 2008

    where to get a thermal fuse 191002393 to send to canada..?

    please help...thanks

  • space_nut May 19, 2008

    Same problem. I owned the TV for 2-1/2 years with no problems, now this. Anyone know if it is difficult to replace the thermal fuse? Any instructions on how to do this?

  • starmito Jul 10, 2008

    i have the same problem with my sony tv kdf e60a20 don't have a clue on how to fix it and i would like to know where to get the fuse from and did it work at all!!!!!!!!!! some one help plzzzzzzzzzzzz

  • Anonymous May 23, 2009

    red light blinking six times

×

Ad

3 Answers

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

My TV KDF-E60A20 is now Fixed. My tv was overheated and Thermal Fuse Located bottom of the lamp burned. I replaced a different Thermal fuse part from 191000644 to 191002393
at www.partstore.com
search for part number. thank you for the review it's help me a lot
thank again

Posted on Nov 27, 2007

Ad

Anonymous

In the manual it says call for service

Posted on May 28, 2007

Ad

Anonymous

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

This is a low b error. the thermal fuse needs to be replaced.It happened to me

Posted on Nov 03, 2007

1 Related Answer

Anonymous

  • 1 Answer

SOURCE: KDF-E60A20 Red Light Flashing 6x

a 6x blinking error code is usually the thermal fuse located above the lamp housing on the light engine. probable cause of failure is clogged fan located in same area or poor ventilation because set is to close to wall [unit requires minimum of 4 inches of clearance]. part # is 1-910-023-93. another possibility but less likely is the gm board which drives the lamp voltage. part # is a1109407a.

Posted on Jul 09, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Sony Bravia TV - Model #: kdl-52z5100 no longer powers on. There's a red light that blinks twice whenever I attempt to power it on. Please help


These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://electro-medical.blogspot.com/

Jul 30, 2016 | Sony KDL-52Z5100 LCD TV

1 Answer

When I turn on the tv it beeps 4 times then the power button light will flash 3 times in a row but the power will not come on it just keeps flashing 3 times


power will not come on Linda, could be bad capacitors or cracked/bad solder joint,bad main logic board.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Samsung TV won turn on blinking red light explained fix 18

Sony Bravia TV kdl red blinking led light error codes solutions

Apr 02, 2016 | Televison & Video

1 Answer

Red light blinks six times. When I hit power button green light stays on for a few seconds, turns off the on for a few more. Then goes back to pattern of red light blinking six times.


the kill switch is open ensure the lamp cover presses firmly on the kill switch when u close the lamp chamber door the red light will stop blinking and u can now turn the tv on

Jul 06, 2013 | Televison & Video

1 Answer

I have a Sony KF 50 WE 610 projection screen TV. It has worked perfectly since I bought it six or seven years ago. This morning I turned it on and the sound came on for a second, but then the sound went...


Hello
Five consicutive blinks at a time and the stops and again blinks five; is its self diagonosis procedure. All modern Sony sets has this function included in its circuits. If the system control IC inside it detect any fatal fault inside its circuits system, it will give a signal to its power control unit to shut it down its high voltage outputs to protect the other components from further damage. In your set; as Sony describes; I quotes:-
  • Five blinks - AKB circuit (automatic kine bias), the timer/standby indicator blinks for about 30 seconds then goes to the self-diagnosis function. Something is wrong with the video. Check video out, Q705, 732, 761 and other components on the C board, also check Q218, 219, 220 on the A board. In addition, unit could be in IK blanking, try turning up screen slightly.
  • Actually the components marked in numberes will not be the same as in your TV. But the fault will it be.
    If you have enough knoledge in electronics and have a concept of soldering and have a good quality multimeter; youreself can do this work by home. OK

    Mar 19, 2011 | Sony Grand WEGA KF50WE610 50" Rear...

    1 Answer

    Picture tube wont lite up after 10 second warmup... sound will come on briefly... then it shuts itself off...red indicator lite near power button is blinking six times in a row over and over?


    that look like if you have a defective power regulator
    or /and a highvoltage transistor defect ;or it just could be a bad soldering in power section or highvoltages
    circuit/
    hope that will help you or
    give you a idea
    tanks.

    Mar 29, 2010 | Sony FD Trinitron WEGA KV-30HS420 30" TV

    1 Answer

    Power problem


    Three blinks - B+ over voltage protection (OVP), unit goes to the standby mode then displays the 3 blink fault. This is also a problem in the power supply circuit, check T603 and R672.

    Jan 30, 2009 | Panasonic PT-47WX42 47" Rear Projection...

    1 Answer

    Sony kdf 55xs955


    Low B error protect is what 6 blinks means on the LA-3 chassis

    Jun 15, 2008 | Sony Grand WEGA KDF-42WE655 42" Rear...

    1 Answer

    Sony rear projection tv


    Mine blinks six times in a row then stops, then six times again and so on.

    Jan 03, 2008 | Sony KP-51HW40 51" Rear Projection...

    2 Answers

    Power Button Blinking Red


    Talli,
    The number of blinks, called error codes, is crucial in determining what's wrong with your unit.. In this case the color wheel is faulty and needs to be replaced. In that unit the color wheel assembly is Panasonic p/n# TXFEN01RP4S and is available from many sources for about $390.00 plus shipping.
    There are some companies like Tri-State-Module that have taken-up rebuilding color wheel assemblies but I can't be certain that this is one of the brand/models they support. If you can have it rebuilt you might save about half the price of a new one...
    For your edification in the future here are the blink codes for your Tv:
    1 | Load Shortage
    2 | Over Volage
    3 | Fan Sos
    4 | Main 3.3v
    5 | Lamp Disable
    6 | Gc3fm-Iic
    7 | Gc3fs-Iic
    8 | Gc3i-Iic
    9 | Color Wheel Stop

    If I can help any other way just let me know...
    Good Luck!
    Bill

    Dec 01, 2007 | Panasonic PT-50DL54 50" Rear Projection...

    1 Answer

    42" Sony LCD Projection


    the manual indicates a six blink is "low B error, no"DD 6V" output from "g" board" the "g" board in a sony is usuall the main power supply board. the center pin of "D1634" is where the +6V comes from, don't short the pins while checking. good luck

    Jan 08, 2007 | Sony Grand WEGA KDF-42WE655 42" Rear...

    Not finding what you are looking for?
    Sony KDF-E60A20 60 in. LCD HDTV Logo

    1,655 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Sony Televison & Video Experts

    The Knight
    The Knight

    Level 3 Expert

    76518 Answers

    Muntejaya Ginting
    Muntejaya Ginting

    Level 3 Expert

    10422 Answers

    Nasir Muhammad
    Nasir Muhammad

    Level 2 Expert

    230 Answers

    Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...