An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: Convergence off on PT-47WX49E
Nyc tech man,
The convergence procedure is covered in your owner's manual on pages 18-21. I will email that manual to the address you indicated above..
To echo what bluenadas was saying about the convergence amps, your set takes two Stk392-110 at pos# Ic7001 & Ic7002. However, yopu could use two STK392-150's or 180's for greater amp rating and more reliability. Don't forget a good heat sink coumpound either.
This unit is also built as a light-box for easy access. That means with a few wire clusters disconnected and some six screws the chassis area slides out of the main body of the TV.
Hope this helps.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Convergence chip could be lose as in solder joints bad sometimes a good slap on the TV side will straighten this out temporarily but not recommended. A service call is the best fix unless your handy at taking it apart and resoldering the chip you can find convergence kits online if you are the handy type :)
i would send a repairman out just to be on the safe side. if you arent sure what you are doing you can only make it worse than it already is and i dont think you want to do that. if you arent familiar with the tv then call a repaiman