My television when turned on stays in standby mode
(the light is red) it turns green for a split second but then goes strait back to red.
does anyone know how to fix this ?
I have tried unplugging for 10 minutes to see if it reboots its self,
also
using the remote controls but nothing seems to work.
anyone any ideas???
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Main board fault. Contact any service technician. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" or "Magazine" will make surf easy Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
Check and replace its main board. Contact any service technician. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" will make surf easy. http://electronicshelponline.blogspot.com/
Try restting it by unplugging the tv for a few mins and it should rest to original factory default settings but leave it unplugged 10-15 mins to be sure.
It occurs when your wii in the Standby, but WiiConnect24 is enabled with Standby Connection is enabled. the content
can also be received when the Wii is left in standby mode.
WiiConnect24 can be turned on or off via the setup setting. While the console is in standby, the power LED indicates the current
status of the standby connection,
Red indicating Standby - wiiConnect is
off,
Yellow indicating Standby - Connect mode is on. If you hold the power button for 3-4 seconds, the
Wii goes into standby mode with Standby Connect off. and WiiConnect24 will not operate until
the console is turned on.
Is the red light flashing at first?
The unit may be going into protect mode. Lets hope it has done the job and the receiver has protected itself from failure. Protect mode can result from speaker wires touching each other or the Amps metal case. Check that first. It can also be caused by unstable ohm loads if too many speakers are connected to any of the outputs especially zone 2. If you can remove all speaker wires and turn the unit back on. If it stays on, turn the volume down on the main zone and zone 2 if connected. Then reconnect speaker wires.
The power supply (AC adapter) is bad. It has enough power to light the red LED, but not enough to power the TV.http://shop.ebay.com/?_from=R40&_trksid=m38&_nkw=12+volt+5+amp+power+supply&_sacat=See-All-Categories
Your problem is in the switch mode power supply or the horizontal out circut.
sometimes the small CHOKE that feeds the base of the horz. out transistor has a cold solder joint.
resolder both ends first.
Thanks Guy9
metal case. Check that first. 
I have exactly the same problem with my Grundig Arganto 82.
×