When Amp is powered on by remote lead, red LED comes on

Amp worked fine, now when the remote lead is switched on the green light with come on for half a second, turn off then the red light will come on. all the wiring is good and triple checked (dropped another amp in its place) what could be causing this and is it something i can fix, i have extensive automotive knowledge, electrical knowledge and basic car audio experience.

speedy82 Mar 27, 2008

I had it hooked up for a day and then it just quit working put a new amp in its place and it works fine.

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.
Contributor
12 Answers

How are your rca ups comming from your deck or did u splice and ad to factory?

Posted on Feb 19, 2009

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

2answers

I have a D-link DSL-2750U router worked fine till yesterday, but now its power led keeps on giving a red light it should give green a second or two later but it keeps givings

Reset router. There are two resets. A simple push reboots and holding it in clears all custom settings. Try the first.

This is a quick fix and usually does it. Test with network cable and work your way backwards to modem if you still have problems.

Read full answer

Nov 11, 2012 • Computers & Internet

8helpful

1answer

Wiring diagrams for clarion dxz535 car stereo

Here's how it goes:
Speaker wires:
grey=right front pos.
grey/black=right front neg.
white=left front pos.
white/black=left front neg.
violet=right rear pos.
violet/black=right rear neg.
green=left rear pos.
green/black=left rear neg.
red=12 volt switched power source
yellow=12 volt constant power source (direct to battery)
black=chassis ground
orange/white=illumination (switched source,not to head light switch)
blue/white=amp turn on lead (to remote turn on lead of amp)
blue=auto antenna (switched power source)
brown=phone mute lead (to cell phone mute lead)
RCA connector leads:
grey lead:
red=right front
white=left front
black lead:
red=right rear/right rear subwoofer
white=left rear/left rear subwoofer
(connect to external amp)
red lead:
red=right aux input
white=left aux input
(connect to external unit)
green lead:
red=right dual zone output
white=left dual zone output
(connect to wireless head phones)
That should be all there is. on the yellow that goes direct to the battery you need to use an inline fuse holder with 30 amp fuse.

Read full answer

Sep 26, 2010 • Car Audio & Video

4helpful

2answers

I have checked all connections to my amp battery,head unit,remote or trigger wire,fuses,power cable,rca leads,ground wire,amp has a green led light on it indicating if it works ok,red if it`s not,light...

Your amp could be in protection mode! Sometimes turning up to high or wires touching will put in protection mode! It will have to be unplugged for a day or two to drain all power out of the memory. Leave accessorie/ignition wire hooked up, just not power and ground wiring. It should reset itself.

Read full answer

Jan 22, 2010 • Lightning Audio B4.250.2 Car Amp

0helpful

1answer

Motherboard won't boot: no noise, no nothing...

Shorting the two leads will work but don't keep the two wires together. They are not ment to stay connected. Consider replacing your cases ATX power switch. Take a look at the link provided for a new switch;
http://www.cables4computer.com/Cases_and_Enclosures/Mid-Tower_PC-Cases_ATX_Push_Button_Power_Switch.html

The green LED on the motherboard means the board is in "Stand by mode". This green LED uses 5V DC to light the LED. After replacing your PS back into your system it may function just fine.

Good luck.
Mike

Read full answer

Dec 03, 2009 • Intel Motherboard

0helpful

1answer

Amp not working to power sub woofer

remote wire/ fuse possible? have you checked?
traced all voltage?take and disconnect remote wire from amp and make short wire from remote to 12v if green light works then u may have bad remote wire or blown fuse.

Read full answer

Oct 05, 2009 • Kicker ZX10001 Car Audio Amplifier

0helpful

1answer

Green power light comes on for a split second, then red.

The power supply (AC adapter) is bad. It has enough power to light the red LED, but not enough to power the TV.http://shop.ebay.com/?_from=R40&_trksid=m38&_nkw=12+volt+5+amp+power+supply&_sacat=See-All-Categories

Read full answer

May 23, 2009 • Proscan 19LA25Q 19 in. LCD Television

0helpful

2answers

Tv won't turn on

yes but you have to open the tv

Read full answer

Mar 01, 2009 • Loewe Aconda ACO9303 30" TV

0helpful

1answer

Jxp720 no sound, light going red to green to red

With your multimeter set to DC volts, the black meter lead on the ground terminal of the amp and the head unit on (so the amp will have remote voltage applied), touch the red lead alternately to the B+ and remote terminals of the amp. If the voltage is below ~11 volts, you need to check the wiring feeding whichever line is too low.

If the voltage remains near or above 12v, disconnect all speaker wires from the speaker terminals of the amp and disconnect signal cables from the amp. If it powers up, the wiring needs to be checked. If it still shuts down, the amp likely has blown output transistors.

The following page can help you troubleshoot the problem if you want to try to repair it yourself.

Basic Amplifier Repair

Read full answer

Apr 09, 2008 • Power Acoustik LT-980/2 Car Audio...

1helpful

2answers

Amp Power LED Display blinks red and no sound

Read full answer

Jan 26, 2008 • Kicker ZX650.4 Multi-Channel Amp - 480W ZX...

0helpful

1answer

Jammer shuts off

To my understanding,the first 30 seconds is a test mode when the blinder will react to a tv remote,after wards the light will remain green until a true laser attack.

Read full answer

May 27, 2007 • M20 X-Treme Radar Detector

Not finding what you are looking for?

View Most Popular

V2118 Car Audio Amplifier

Car Audio & Video

I have a D-link DSL-2750U router worked fine till yesterday, but now its power led keeps on giving a red light it should give green a second or two later but it keeps givings

Computers & Internet

Open Questions:

0answers

Kenwood 7252 1000w amp red light When I turn the switch on in my car a red light comes on in the triangle on the amp. everything works fine as it should just confused. just got the amp and there isn't much about it online I just know usually red doesn't mean good

Read full answer

Be the first to answer May 16, 2022 • Kenwood Car Audio & Video

0answers

Aiwa TS-W 50 LH SUBWOOFER I need eletronic diagram this subwoofer

Read full answer

Be the first to answer May 16, 2022 • Aiwa Car Audio & Video

0answers

2013 Nissan Note. My navigation SD card was formatted or info deleted where can i get a new one or how to get the software back on the SD card. Clarion MC313D-A/w/wm

Read full answer

Be the first to answer May 14, 2022 • Clarion Car Audio & Video

0answers

I have a Kenwood Multiple CD Player DP-M993 6 Disc Player and need to know the Unit Number for the Remote Control The Kenwood DP-M993 is from 1993 and did not come with a remote control. I am looking to buy a used remote Kenwood RC-P7730 CD player Remote Control contol but the Remote Control Unit numbering system does not match the CD Player model number. There does not seem to be any information on the remote control for this specific model. Can anyone help? Also, there are similar Kenwood models such as the Kenwood RC-P7730 CD player Remote Control that have the same type of functions keys and build arround the same time period. Would it work?

Read full answer

Be the first to answer May 09, 2022 • Kenwood DP-M993 6 CD Changer 1 Compact...

See all Visonik V2118 Car Audio Amplifier Questions

241 views

Ask a Question

Usually answered in minutes!

Are you a Visonik Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for Visonik V2118 Car Audio Amplifier? Or just drag it here!

Related Topics:

When Amp is powered on by remote lead, red LED comes on