E077 Error I have this problem. please send me how can i resolve this problem. thanks regards.

Hello,

Thanks for choosing Fixya.

I hope this apple forum discussion will resolve your problem.

http://support.apple.com/kb/TS1421

Thanks & Regards,
Chandrashekhar

Hello; that's transfer drawer connector problem, check the connector.

Hello,

This error code means the wireless connection within range is not compatible or not configured. Please visit the following link for tips to resolve this issue.

Click Here

Regards,
G33k

Hi


Thanks for using FixYa. Error code F1 indicates primary control failure and to resolve this you?ll have to replace the machine control assembly. Yes you are right, this error should be fixed by whirlpool as its a common issue with whirlpool Cabrio washers, you can call 1-800-253-1301 whirlpool will send a tech. to fix it and pay for the part. Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

Hi


Thanks for using FixYa. Error code F1 indicates primary control failure and to resolve this you’ll have to replace the machine control assembly. Yes you are right, this error should be fixed by whirlpool as its a common issue with whirlpool Cabrio washers, you can call 1-800-253-1301 whirlpool will send a tech. to fix it and pay for the part. Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

Check you hard drive for errors and try to repair it.

START -> RUN -> type CMD press enter -> you will be redirected to dos prompt.

There type CHKDSK C: /r

Repeat the same process for all drives.

This should resolve the issue then you need to replace the hard disk drive.

Thanks & Regards
Nandu :)

Hi pilchuck3,
please click on following link and which will help to how to access the ECM (Error Correction Mode), Please turned it off and i thing your issue should be resolved,
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00313088&cc=us&dlc=en&lc=en&jumpid=reg_R1002_USEN


Regards,  raj_p5983

Hi,

I understand that you are receiving the error "fax not sent" and the transaction report Error 389*. while sending fax.

The issue that you are experiencing is due to communication, however please follow the instructions from the below article to get the issue resolved.

Here is the web document:

================

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=buu02549

================

Just copy and paste the entire link into the Internet browser's address bar and press enter.

This should resolve the issue that you are experiencing with.

Regards,
Lawrence

Try to send the fax at a different time when telephone line conditions have improved.
Or try to disable the ECM on yuor printer, to do that to these steps:

Press SETUP
Press DOWN until you ADVANCE FAX SETUP displays
Press OK
Press DOWN until ERROR CORRECTION MODE displays
Press OK
Press RIGHT ARROW to turn it off
Press OK

Then try to send new fax. If this does not resolved your issue pls try to go to your phone provider. Thanks