Won't stay turned on.

When powered up the screen shows the AKIA in great color but then immediately shuts down followed by a short buzzing noice and then restarts for a few seconds and shuts down repeating this sequence over and over but simply own't stay on.

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.
Contributor
76 Answers

Sounds like power fault but shouldnt be too expensive to repair,get local service center to check it out for you.,

Posted on May 14, 2007

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

How to fix 3 flashing lights?

Look for a thermistor near the lamp and ballast

Read full answer

Aug 22, 2015 • Samsung HLS6186W

0helpful

1answer

Samsung s3 phone wont turn on only red light stays on and a buzzing noise sounds and wont turn on need help

Shut it down by holding the power button until the screen goes black, don't tap the power off button, wait for the black screen. Then let your phone charge for a few hours (maybe over night) with power off and see if that helps.

Read full answer

Dec 12, 2014 • Samsung Galaxy S Iii S3 Gt-i9300 16gb...

0answers

My Akia LCD tv won't turn on. Had problems before

Read full answer

Be the first to answer Nov 27, 2012 • Televison & Video

0helpful

1answer

HP M7357c overheating problem

When the CPU in the computer or laptopoverheats then it will shut down (i.e. thermal overload) and won't boot upagain until it has cooled down. If this is the problem is not fixed then theCPU will eventually fail.
A faulty fan causes this problem or the fan and heat sink assembly are cloggedwith dust.
Check the CPU fan to see if it spins freely, if not replace the fan. If the fan and heat sink is clogged withdust the remove the dust and make sure the vents are clear and dust free. Use acan of compressed air to do this.

Read full answer

Feb 03, 2012 • HP m7357c PC Desktop

0helpful

2answers

WINDOW XP WOM'T SHUT DOWN

Hold the power button in for a few seconds it will shut down. Then unplug system and push the power button down with it unplugged then replug it in and power up again. Then do a proper shut down again to see if the problem fixed. I hope this assisted you. John

Read full answer

Feb 07, 2011 • Microsoft Windows XP Professional

0answers

Phillips 47PFL3603D/27 Immediately after turning

Read full answer

Be the first to answer Aug 17, 2017 • Philips Televison & Video

1helpful

1answer

Hp flat panel monitor comes on shows logon and then blank screen

Ok, another words, monitor powers up for few seconds and shuts down by itself. If green LED on the front panel turns off as well or stays on?
If stays on, then inverter turns into protection mode because of old backlight lamps.
If it turns off in same time with an image on the screen, then there are some bad electrolytic capacitors in the power supply.

Read full answer

Sep 11, 2009 • Dell E152FP 15" Flat Panel LCD Monitor

0helpful

1answer

Mrv F345 power cut out and now the screen flashes blue

disconnect all of the speaker wires at the amp and turn your system on -if the amp stays on then you likely have a roasted coil in one of your speakers somewhere and causing a short which is shutting your amp down into protection mode-if the amp wont stay on with nothing connected to it then you have probably roasted something inside the amp and uhhh good luck bro

Read full answer

May 09, 2009 • Alpine MRV-F345 Car Audio Amplifier

0helpful

1answer

Akia lct2070 screen went black and will now shut its self off

You may need new inverters, CCFL's, or your power supply is not [providing regulated 24 volts...

Inverters
CCFL assembly
power supply

We have these Akai boards in stock if you need them.....

Read full answer

Dec 25, 2008 • Akai LCT2060 Television

0helpful

1answer

Screen stays blank after turning it on.

Hello, The blinking pattern you're observing is a result of a heavy current load on the power supply. The power supply could be defective but more than likely the scan or sustain boards have a direct short on them causing the power supply to shut down and display the error. A technician will be able to determine where the load is coming from and replace the appropriate board or component. I hope this helps you. Joe Weibel CustomElectronics.Org

Read full answer

Feb 28, 2007 • Maxent MX-42VM 42 in. Plasma HDTV

Not finding what you are looking for?

View Most Popular

LCT2701TD Television

Televison & Video

How to fix 3 flashing lights?

Samsung HLS6186W

Open Questions:

0answers

steady blinking red light

Read full answer

Be the first to answer Feb 02, 2014 • Akai LCT2701TD Television

0answers

Fuente de alimentacion MLT169B Tengo todas las tensiones menos la de 12V y la tension de los 24V

Read full answer

Be the first to answer Jan 17, 2014 • Akai LCT2701TD Television

0answers

power supply schematic diagram

Read full answer

Be the first to answer Oct 29, 2013 • Akai LCT2701TD Television

0answers

megmeet mlt169b whatis the zener voltage of "Z3" which is connected to a 20 ohm resistor?

Read full answer

Be the first to answer May 16, 2013 • Akai LCT2701TD Television

See all Akai LCT2701TD Television Questions

124 views

Ask a Question

Usually answered in minutes!

Check Out the Latest HD Televisions Report

View all Fixya Reports

Are you an Akai Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for Akai LCT2701TD Television? Or just drag it here!

Related Topics:

Won't stay turned on.