WORKING SO SLOWLY - HEWLETT-PACKARD Computers & Internet

am getting the message Raise the Needle Bar slowly can find anything about...

Raising the needle bar usually means just turning the handwheel slowly toward you by hand.

http://www.lmgtfy.com/?q=What+is+an+antonym+for+slowly%3F

try to clean C: dickdriver and stop runing all program in the same time and you need to have new Ram like 1 GB or 2 GB with the same frequency

You should open the tank valve slowly if after opening i takes more than 3 seconds to get up to pressure something is not working properly. FOR SAFETY GAUGES ARE SUPPOSE TO BE FACING AWAY FROM U WHEN PRESSURIZING. IF GAUGE IS DEFECTIVE AIR PRESSURE CAN BLOW GAUGE LENS OUT FRONT OF GAUGE.

Try it again! i just did mine and it works. I took the remote and pressed the button on the remote the same time as the button in the car. It started blinking slowly and then rapidly as stated in the instructions. I then hit the learn button on the opener motor and pressed the car button two times. It works like a champ!

Maybe your mouse in malfnctioning. It depends how it is use or the product itself. You must configure the mouse on control panel.

Removing the casing of a notebook is a tough job. Even after removing the screws, the covers won't come out. The reason being the clip locks aroung the edge.
Slowly pull apart the two sides (top and bottom) from one place and push a screwdriver through the opening. (Don't push it too far or you will damage the circuitry). Push another flat screwdriver inside close to the first one. Slowly drag the second one along the edge. If the casing resists opening at one place that means there is a clip lock there. Slowly push the screwdriver handle downwards. If you are lucky, the lock will open. If it doesn't work push the screwdriver handle upwards. (I've not opened this particular type of computer, so you have to check and see). Once a lock opens insert the first screwdriver there to prevent it from closing again.
Slowly work around the edge to open all locks.

lens has to be clean

ther printer

turn the psp on and then hold the power switch up until it turns off and then turn it back on