I put a dishwasher cleaner in and ran the dishwasher. Now the dishwasher does not run. It is a whirlpool quiet partner II

You just need a new door gasket and it is a cost effective repair if it still works okay for about $20.

https://www.google.com/search?q=Whirlpool+Quiet+Partner+II+Energy+Star+8575637+door+gasket

..

Sounds like broken glass in the drain pump.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jeffrey_634abadf963e31e5

the first thing to do is unplug it for 3 minutes then check to see if it reset by running

If pushing and holding the lock button till the light goes out doesn't work, you likely have a problem on the circuit board.

I had the same problem with my dishwasher. After hearing that the motherboard was the problem I decided to take a closer look. There were two capacitors (1000 microfarads, 6.3 volts) that looked a little suspect. The tops of capacitors should be flat...these looked like soda cans that had been left in the freezer. Got on eBay, located the capacitors for roughly $3 and $4 shipping, for approx total of $10. Soldered the two new capacitors into the motherboard and put it back together. As soon as I closed the door, the dishwasher started draining the water. When I ran a Normal cycle it completed successfully. Saved myself over $120!

This dishwasher has a thermal fuse that attaches to the main control board that may have failed, it can be tested with a meter for continuity if it does not have continuity then it is your problem.

ok first prime the sink then put a table spoon of tang in dispensor then run the unit this will clean the dish washer

Hello Tx_smiths! We are terribly sorry to hear of your concern with your Whirlpool Dishwasher. Please respond back to this email address [email protected] with your name, reviewer name (Tx_smiths), phone number, street address, zip code, model & serial number, and date of purchase on the appliance. We would be happy to assist you. We look forward to your reply.

rw2fanru quiet partner IV wont drain water

clean light blinkin???? ry pushing the sanirinse-heated dry--sanirinse--heated dry. tha tshould put in diagnostic mode, there also should be a trouble shooter underthe lower acess panel