Whirlpool LSB6300 died mid-cycle now only clicks

I had the same problem. The washer control board has an intermittent failure. If you unplug power for about 30 minutes then plug it back in you will get a PF code (power failure). Ignore this code and push start again. It may run till it finishes the cycle or it may start cycling again right away. A new board costs about $180 at repairclinic.com

open the lid look under the lid middle center on frame or tub the gap bewtween the lid and console....

you need to replace a component called the"capacitor".this should solve the problem.

i have the whirlpool top loader also. Was not quiet a year old, starts running at random by itself. They sent the repair man out got lectured that it was my fault (too much soap, washer is in basement, I need to call an electrician to check the wiring). Now it drips water into the inside of the washer.
I can see it will eventually be cheaper to replace than call the repairman back.... Won't be a Whirlpool

I fixed mine with a toothpick and a piece tape. Make the tab on the door longer that activates the switch. Try triming the lid bumpers

Sounds like the belt broke and probably need replacing or the motor is shot.

Hello, you may have a small drip from the pump or a small drip from the hose that goes from the pump to the rear of the cabinet. To make sure you will have to run the unit with the cabinet removed. A local service tech can remove the cabinet quicklyand isolate the leak.

Remove the pump system like this off the Hotpoint wd640 . Remove any blockage inside and retry.

what kind of click are you hearing like a timer advancing or a hum them a click about every 10 minutes and dont rate me yet till were done