Question about Brother HL 2700CN Laser Printer
For some time now, I've been getting the error message "Error EE9". The brother FAQ guide only says to restart which I've done and it sometimes works. Now it just will not go away and I can't print. Anyone know what to do? By the way, I have my printer directly connected via USB to my iMac G5 and I'm using the OS 10.4 printer driver.
This is a sensor error (belt marker). Could be a piece of paper or such stuck in there from a previous jam futzing up the sensor. Are you comfortable poking around inside your printer?
Posted on Apr 24, 2007
Check the OPC belt on the left side. Fill in any clear areas, except for the actual sensor mark, with a "sharpie" pen. This worked for me.
Posted on Nov 06, 2009
I solved this problem by turn sensor on 180 degree.
This sensor located near to top of belt.
Unscrew fixing of sensor.
Remove sensor carefully without damaging the plastic latch.
Turn sensor on 180 degree. Put it back and fix screw.
Posted on Mar 27, 2010
Clean the sensor at the top left side of belt. On the left edge of the belt you will notice a couple of black squares, these are the belt sensor markers. Clean any toner on the edge of the belt that might be seen by the sensor as being a marker.
This worked for me after turnning the printer off and on many times and getting the EE9 error. It is also possible that a piece of paper could get stuck in the sensor but it is more likely the probelm is toner on the left edge of the belt.
Posted on Apr 11, 2012
If this doesnt work then try and empty any waste toner from the photodeveloper cartridge and clean with a soft cloth to enure you dont scratch the film. If this fails, then its a new part im afraid :( -
part no OP4CL
Posted on Nov 15, 2007
Replace opc belt
Posted on Oct 13, 2008
The EE9 Error was referring to the OPC Belt Cartridge. It locked-up and was making a very loud sprocket, grinding noise. I'm now ordering a new OPC Catridge.
Posted on Mar 11, 2008
Tips for a great answer:
Usually answered in minutes!