Missing Usbccgp.sys - Computers & Internet

Dear,
When you install xp service pack 3.You must be install service pack 3 supported driver for your printer.
You install this driver then all are OK.

the file is corrupted. find a replacement

As long as it's a fairly new printer, 2000 +, just when you get to the compatibility screen select to install anyway. This happens because the drivers weren't signed by microsoft for use with xp.

ITS EASY JUST COPY THE FILE pci.sys from any other computer from System32/DRIVERS/pci.sys .SOUNDS FUN?BUT I KNOW IT WORKS

I try to transfer pictures from camera to kodak Easyshare and it says I need the file DcPtp. sys' on Eastman kodak, where do I get this?

Plese make sure that your USB port is enabled in BIOS Mode,

if it is enabled make this steps....


Download USB Driver files....

usbehci.sys
usbport.sys
usbhub.sys
usbui.dll
usbccgp.sys
usbohci.sys

If you are running Windows 95, Windows 98, type:
copy himem.sys c:\windows <press enter>
If when typing any of the above commands you receive a prompt that the file already exists, ensure to overwrite it.
Reboot the computer; if the issue continues to occur, verify that the config.sys is properly setup. The line himem.sys should read:
DEVICE=C:\Windows\HIMEM.SYS
or
DEVICE=C:\DOS\HIMEM.SYS
Additional information and examples of the config.sys can be found on our autoexec.bat / config.sys page.

Steve go here
http://www.logitech.com/index.cfm/405/&cl=us,en?prodcrid=405

look for yor camera model, click download software then choose your operating system on the next page that will give you the logitech software that you need to install to fix your issue

Hope that helps

you need 2 update the software go to rca.com

Boot into recovery console, and at the c:\windows prompt type: cd system32 cd drivers ren ntfs.sys ntfs.old If the ntfs.sys file is there and corrupt this will rename it. If it is not there, then it was missing. At the prompt type: copy e:\i386\ntfs.sys c:\windows\system32\drivers\ntfs.sys good luck