My image is blurry - it looks like there is a slight "ghost" image offset from the main image by approximately 1 mm to the left. I assume there is a calibration with a potentiometer (POT) that will allow me to correct this offset? Can anyone direct me to the right POT or other electronic calibration? Or, does anyone have a schematic for the Plasma TV that I can use?
Akai does not seem to have a "support" section on their home page??
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Porblem solved, It's a wonderful day.... Ahhhh, it is now FIXED and working great. I found cracked solder joints on a few of the switching power transistors and some of the big diodes and other heat producing parts. Also notice that the infamous Red caps C524 and C523 were discolored but they checked OK on my cap meter and also my ohm meter, however while I was inside the set after removing 1 million scews I decided to replace them anyway. I hope that my repair success helps someone. electricitym
The Power Supply Board is listed below. Please note, there are 2 models with the same beginning number (PDP4294). Verify your model number before selecting the Power Supply Board as each board is different depending on the model number.