Philips HDTV error code

Good day!!!

if you have power problem without blinking lights or standby lights (red) the possible problem is power supply board..However if the TV have blinking or standby light but won't turn ON..there are multiple cause of that and need further troubleshooting..

Sounds like you have a power supply problem within the TV. It will need to be serviced.

1- bad scaler bd. 2- short or open fuse on t-con bd. disconnect lvds cable from scaler bd. to bd. on back of panel if stays powered u got it solved 3- swollen capacitors in power supply

its your capasitors in your power supply board you can see other post for help. I took panel off mine and removed power supply board and took it to a electronic shop and fixed for $25. just note where wires replug back in. you can take a picture of how wires are plugged in for reference. if you kow about electronics you can replace them yourself for about $7 the two caps will cost about $2 and shipping...

Power supply board is dead.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Not sure what code since you didn't say, but here is the code breakdown.

When the TV does this, the RED LED on the front will blink. For digits 1-10 it will blink pause then repeat. For numbers with 2 digits it will blink the first digit slow and then second digit fast. So 25 would be 2 slow blinks followed by 5 fast blinks.
Error Description Error/Prot Detected by Device Defective module Result
1 I2C1
2 I2C2
3 I2C3
4 I2C4
5 VIPER
6 5V supply
7 8V6 supply
8 1.2V DC/DC
11 3.3V DC/DC
12 12V supply
14 Supply Class D amplifiers
14 Supply Audio part SSB
17 MPIF1 audio supply
18 MPIF1 ref freq
25 Supply fault
27 Phoenix
28 MOP
29 AVIP1
31 AVIP2
32 MPIF1
34 Tuner1
37 Channel decoder
39 POD Interface
43 Hi Rate Front End
44 Main NVM
45 Columbus
53 VIPER
63 PDP Display

internal breaker, hopefully that xbox is plugged into a 3prong ac outlet. unplug the tv from electricity for a half hour and that circuit breaker inside should auto reset.

these tv have a comon short problem w the video &audi bord shield if you remove the cap only it usally fixes this

No, I don't think you have a lemon, you have a great TV. It is just to complex for you to fix yourself. I think you have a ADC that went bad and needs to be checked out. You need to have a service adjustment done by your Service Tech. You just can't fix the ADC without clearing the buffers, and all the other procedures needed to fix this TV. I think your TV repair persons are probably just going over the complex procedures to fix your TV. This TV is real special, complex but, simple too. It has some 5 digit error code buffer procedures, I have never seen on any other sets. I do think you will need one sharp Philips Service Tech, and maybe Philips can help you with that if they haven't already. If you are not getting response from your Service Tech, I'd call Philips or a certified representative and have them get you one now. You shouldn't have to wait because, the local service techs haven't done their homework, or can't do the work.

Click here for a Philips service site, if needed.

If u want to see what model the tv is without taking it off the wall enter this code with your remote. "123654" on the first screen it will have your model number and serial number.
As for the error 6 its a 5volt supply error.
And for error 5 you have a bad osc crystal.