I took several pictures just fine. The low battery signal came on, I took the old batteries out and installed new ones. Camera will not turn on now. I installed the batteries correctly. I used several new batteries also.
I was in the middle of taking a picture and my screen went blank. Thinking the batteries were dead, I put in new ones. Now my camera will not turn on at all. No screen, no lights.I was in the middle of taking a picture and my screen went blank. Thinking the batteries were dead, I put in new ones. Now my camera will not turn on at all. No screen, no lights.
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Suspect dirty battery terminals that may need to be cleaned, or bent upwards, to improve contact with the batteries. Troubleshooting tips for this problem may be seen here.
its just a matter of batteries...some are not powerful enough to operate the camera ....Try to change them and buy some real good ones..like Duracell or Tatra...do not make any compromises when buy the batteries...get the best cause these kinda cameras really require powerful ones...or ...try to get a set of rechargeable ...
this is not a good signal. you can make this prove. clean the internal camera contact with a specific contact spray and one cotton fioc ore you can use normal denaturated alcohol. this is one possibilty. if you dont have any betterment. its probably that the camera have a eletronic defekt. this is not so uncommon with old camera. the camera have internal fuse the works not good and gives this problem. motherboard defekt. good luck i hope for you that is only a dirty contact faulty. paolo
Have you tried a new filmpack. Reason for asking is if you have an old filmpack, since the batteries are stored in each filmpack, sometimes expired or old filmpacks have been sitting around and lose some of their power. This makes the battery dead or low voltage that can drive all the shutters and lens focus, but fail to extract the film after exposure. Also check your rollers in front that they move and the gear on the side for wear. Another test is to set the flash on and time how long it takes for the flash to get ready. Anything over one minute is too long and I would replace the filmpack with a newer one. BTW: Most 600 filmpacks are old and stored for long periods.
SOLUTION: Fot the past two years, fully charged NiMH and new alkaline (generic and fresh Name Brand batteries) in my CX7530 always gave a red light and immediate power off -- symptoms of low batteries. Today I tried it again with the same problem. This time, I folded up a small piece of stiff paper to depress the small Lithium battery module detect switch in the battery compartment, and put my NiMH batteries back in -- it WORKED for the first time in two years! After removing the paper and reinserting the batteries, it still works. I suspect this somehow recalibrates the low battery detect circuit. I hope it helps you as well.
This happened to me too. I did some research and if you were using anything other than alkaline or NIMH batteries (I was using Nicd rechargables) it will fry the circuit board. That's Sony's way of making sure you use their rechargable batteries only (or buying costly alkaline). Our cameras are fried. Time for a new one.
i have same problem i changed batterys now i have no screen lighting up just light flashing and beeping
I was in the middle of taking a picture and my screen went blank. Thinking the batteries were dead, I put in new ones. Now my camera will not turn on at all. No screen, no lights.
×