Unlock key pad on samsung t245 - Samsonite Silhouette 11 HWatch

https://www.youtube.com/watch?v=hmQwEipEdFA
watch this video. you already have your unlock code so ignore the process until he explains how to put in the unlock code. Make sure you do it right because i think you only get 4 attempts at it.

To use your AT&T Samsung Galaxy S3 with T-mobile network,you need to unlock it from current provider.Get the unlock code from the site Simpleunlocking.com and get free Unlocking instructions from the site Mobileunlockguide.com ,unlock it step by step easily.

this is a big job

"bf" stands for "Back up failure. Your system communication to the monitoring station is working on phone lines only if it's tied into them. I would call the monitoring station and see if it's still communicating.

press on the MR/C (set) button. This button is located on the calculator buttons area of the watch. Hold this button until the date begins to blink. you select the numbers you want to set the date and time to by pressing the correspondent numbers on the key pad. once the date and time is set press the enter key.

blanck disply

hi lagathon121 I had the same problem after i replaced the battery and what i did was to short the + end of the battery plate with the - end for two seconds, apparently this will reset the watch. there is also a sticker pasted on the battery plate holder.

Press the lower button on the left side of the watch to enter the menu. Then press the alarm selection key (5). Use the 1 and AB keys to scroll through the existing alarms. Once on the desired alarm, press and hold the upper button on the left side until the left number on the hour starts to blink. Use the number pad to select the desired alarm time. You can scroll past unneeded number spots by pressing the lower button on the left side. When finished, press the upper left button again and you are good to go. A quick press of the upper left button will activate or deactivate the alarm. Make sure the black lines near the upper left button are visible to indicate the alarm will go off.

Turn the alarm off two times. If it still indicates A/C not ready, press the * key and it will tell you what zone is open or what zone has a low battery.