Question about FreeMotion I7.7 Incline Trainer Treadmill

1 Answer

Incline not working

Incline is stuck at 30 degrees. Everything else works.

Posted by balata384 on

Ad

1 Answer

Ted Bowman

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

The Trainer is reading; Serching for motor controler

Posted on Oct 07, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Adjust incline on weslo cadence g 5.9 bought it used no manual


On the rear of walking deck you have the left and right feet. Down the deck is at 0 degree incline, fold them up and you have a 3 degree incline.. You have no incline motor on this model.

Mar 02, 2015 | Cadence Weslo 825 Treadmill Walking Belt

1 Answer

Incline does not work but incline motor runs for 3 to5 seconds proform415ct


if the motor tries to work but incline does not go up something is jammed on the treadmill or the incline motor is bad

Oct 17, 2014 | Proform 415 CT - Treadmills

1 Answer

What is wrong with and how can I fix the incline on my Nordictrack commercial 1750 treadmill?


This sounds as though the motor is bad, they cost around $130.00, ther is a n electronic controller that controls it, but as it is trying to raise I would think that the switch and controller are functioning. Best of luck and please post back f this helps.

May 25, 2014 | Nordic Track Commercial 1750 Treadmill...

1 Answer

The incline don't work


1) LUBE the shaft from Incline Motor very important
2) Tight the connector that connect in the controller board motor , take the cover where the main motor is. and look for the connector.
3) Looke for some loose wires and tight.
4) Measure 110Vac in Elevation or Down, if does not have see if there are Limit swicht and test it, and replace if Do not have l.switch y use Capacitor test it if there faulty, replace.
5) If everything is Good, test the Incline motor, and see if ok, applying 110vac direclty, disconnecting all wires from the controller board motor.
If not Work, replace.
Blessing.
[email protected]
cell+whatsAPP:+50588611441

Oct 23, 2017 | Exercise & Fitness

1 Answer

Incline raises full and wont go down,t84


1)signal false coming console or display board
2) main motor controller is faulty.
3)Pot attached of the elevation motor ,need adjustment
4) geared slip from elevation motor , carring false signal to console.
Proceed to Test it.

Dec 11, 2011 | Horizon T84 - Treadmill

2 Answers

My proform tl 585 is stuck on an incline. when i try to lower the incline, the button does nothing. the incline could still raise, but obviously i'd rather lower it than raise it more.


Take the cover off and inspect the wiring. Make sure all the wires from the incline motor are connected.
If all the wires are connected and everything looks OK, try the incline again.
There are only 3 wires on the incline motor, red, white and black. This machine does not rely on any electronics to operate the incline. We know the motor works, because it will go up..Likely the switch in the console is defective.
To lower the incline, reverse the black and red wires, that will make up go down and vice versa.. If that doesn't work, the motor is likely defective.
The incline motor is available, around $110. To order find the model number on the frame of the treadmill and call the service number found there. Have your model number ready (starts with "P").
The console is no longer available.

Feb 27, 2011 | Proform 585 CS Treadmill

1 Answer

Merit 725T. The treadmill has gone into a "10 degree" incline mode on its own, and will not respond to the control panel to reduce the incline.


Merit 725T. The treadmill has gone into a "10 degree" incline mode on its own, and will not respond to the control panel

Sep 21, 2010 | Horizon Fitness Merit Fitness 725T...

1 Answer

The Incline is stuck at an angle


Check the motor and the gears that run the unit up and down. If is located on the front of the unit under the face plate. make sure everything is power everything. Also check the gears to make sure they did not break and check the tracks to make sure it did not fall off the track causing it to stay up

Feb 21, 2009 | Epic View 550 Treadmill

1 Answer

Temp stuck on 100 degrees


try unplugging the range for at least 30 minutes

Feb 08, 2009 | Amana ACF3355AS Gas Kitchen Range

Not finding what you are looking for?
FreeMotion I7.7 Incline Trainer Treadmill Logo

Related Topics:

304 people viewed this question

Ask a Question

Usually answered in minutes!

Top FreeMotion Exercise & Fitness Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

ray gallant

Level 3 Expert

68345 Answers

johobikes
johobikes

Level 1 Expert

56 Answers

Are you a FreeMotion Exercise and Fitnes Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...