Need a remote control for Sampo pme 42-s6 (s) TV

If you go on the Website for either the TV Manufacturer or the Universal Remote Manufacturer, you should be able to find the codes that will "marry" your remote to your TV.

The process is something "like":

Hold down button on remote until it blinks
Type / Press Code
Hold down button on remote until it stops blinking.

The remote website or manual that came with it will have the exact procedure.

The key to the whole thing is the code (make sure you have the exact code and TV Model.

I hope that you have gotten this resolved, but if not, or if you have any other questions, here are the codes and some simple steps to run through.


1. Hold down the clear TV button until all lights light up at the top of the remote
2. Punch in a 3 digit code (provided below)
3. Press the # (POUND) button
4. Try powering the tv on/off, and the volume. If one or more of these functions do not work, start over from step 1 with a different code

246
730
746


Becki Barned
DISH Network Customer Service

Here are the instructions for unlocking digilogic devices.

I hope that helps.

I am getting rid of my sampo.  I am willing to sell the tv brackets or the stand or the wall mount as well.

I have a PME-42S6 on Ebay that has a turning on problem it is a complete unit and work good if you can get it to turn on

Ebay # 120362175465

bid on it and pick it up and there is your stand.

Bob
678-333-6746

Same problem red alarm led comes on you need the power supply unit it's $139.00 you can fix it your self. And gateway dont have to parts i have a phone #

do you know if your power supply board will work for the Sampo 42S6?

If so, I am interested.

[email protected]

I have a PME-42S6 on Ebay that has a turning on problem it is a complete unit and work good if you can get it to turn on

Ebay # 120362175465

bid on it and pick it up and there is your remote control
Bob
678-333-6746

I have the same exact tv this sounds like a previous problem that we experienced we resolved ours by plugging into a grand video console. Good luck! Tammy [email protected]

A digitalizing picture is most likly a bad connection on a screen driver cable or the driver itself is intermittant or the power supply has an intermittant filter on the substain B+ line. hope this hellps.