The tv shows the red light when plugged in. When turning on set... the red light flickers from red to blue, red to blue, red to blue while holding power button. When you release it, it goes back to red. The unit will not power on. Any ideas?
I have a Polaroid 4641 TLXB LCD 42 inch, when i turn on the tv nothing happens. The red light keeps flickering on & off, on & off etc...I have a Polaroid 4641 TLXB LCD 42 inch, when i turn on the tv nothing happens. The red light keeps flickering on & off, on & off etc...
AnonymousApr 02, 2008
i have the exact same problom with the exact same modeli have the exact same problom with the exact same model
Polariod FLM-2011 is about 16 months old. Will not turn on - just flicks from red/blue/red when the power button is pushed.Polariod FLM-2011 is about 16 months old. Will not turn on - just flicks from red/blue/red when the power button is pushed.
AnonymousMar 21, 2014
red light on the front stays on but doesn't blink or turn blue.red light on the front stays on but doesn't blink or turn blue.
AnonymousMar 29, 2014
no power no red ligth and blueno power no red ligth and blue
You can't post conmments that contain an email address.
Same problem here. There is a blurb on page 18 of the owners manual that talks about the fuse that protects the tv from a power surge. If the fuse is blown, the TV won't power up.
I haven't checked mine yet. The tv just started acting up. If and when I pull it off the wall, disconnect all the cables, pry off the cover from where the fuse is located, I'll re-post with my findings.
Just curious if a blown fuse resolved anybody else's problem??
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I recently fixed my 955 headphones... it's probably not going to be attempted by most folks, but it saved a great set of headphones from being tossed and replaced.
Basically you need to remove the right side padding and take out the 3 screws. This gets you access to the battery. The battery is a standard 3.6V lithium battery. Pretty much the same that is in most cell phones and many small toys. You can simply replace the battery with something like: http://dx.com/s/3.7v+li
Or... here's what I did... add a lithium USB charger to the battery. http://dx.com/s/li+arduino Now, if the battery dies I can plug it into USB and the phone will work while it charges.
It sounds like you need a new power supply, You and find one on amazon around $14 too $18 dollars maybe less, if that not your issue then it's going to be a fuse but since you can see the light it should be the power supply.
The power supply board was having problems before.That the board,where the power a/c cord plug into it Now might also the Tuner board are dead too.The tv Tuner board,that the board where the tv broscast signal cable plug into it.That the Tuner board.Tries Websites like shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement to see if solved the problem,not probally will have to buy the refurbish Tuner board for the replacement too.
1. Turn
off the PS3 so it only shows a red light. You can hold the power button
on the front until it goes into standby. To be sure, flick the power
switch on the back of the Play Station 3 off and then back on.
2.
Make sure your Play Station 3 is connected to your regular TV (not
HDTV) with the standard video cables.
3. Press and hold the power
button until the screen "flickers" and then immediately release. This
should reset the video settings.
4. Wait a few seconds, and the
Play Station 3 (PS3) logo should appear.
If this does not resolve
the problem, follow these steps:
1. Turn off the PS3 so it only
shows a red light. You can hold the power button on the front until it
goes into standby. To be sure, flick the power switch on the back of the
Play Station 3 off and then back on.
2. Make sure your Play
Station 3 is connected to your regular TV (not HDTV) with the standard
video cables.
3. Press and hold the power button on the front
until the Play Station 3 beeps and then turns off again. This should
reset the video for you and you can turn it back on after this.
1. Turn
off the PS3 so it only shows a red light. You can hold the power button
on the front until it goes into standby. To be sure, flick the power
switch on the back of the Play Station 3 off and then back on.
2.
Make sure your Play Station 3 is connected to your regular TV (not
HDTV) with the standard video cables.
3. Press and hold the power
button until the screen "flickers" and then immediately release. This
should reset the video settings.
4. Wait a few seconds, and the
Play Station 3 (PS3) logo should appear.
If this does not resolve
the problem, follow these steps:
1. Turn off the PS3 so it only
shows a red light. You can hold the power button on the front until it
goes into standby. To be sure, flick the power switch on the back of the
Play Station 3 off and then back on.
2. Make sure your Play
Station 3 is connected to your regular TV (not HDTV) with the standard
video cables.
3. Press and hold the power button on the front
until the Play Station 3 beeps and then turns off again. This should
reset the video for you and you can turn it back on after this.
I recently fixed my 955 headphones... it's probably not going to be attempted by most folks, but it saved a great set of headphones from being tossed and replaced.
I have a Polaroid 4641 TLXB LCD 42 inch, when i turn on the tv nothing happens. The red light keeps flickering on & off, on & off etc...
i have the exact same problom with the exact same model
Polariod FLM-2011 is about 16 months old. Will not turn on - just flicks from red/blue/red when the power button is pushed.
red light on the front stays on but doesn't blink or turn blue.
no power no red ligth and blue
×