At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
SC 570 means Fusing oil end.
You have insufficient oil in the oil tank situated at the rear of the machine, please fill up with correct oil.
Afterwards please enter SP mode 5-810 and set to 1, then switch off and on the machine.
If you have sufficient oil in the tank and sc570 re-occurs, you have a defective oil pipe, oil pump or oil end sensor.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You need to refill the oil [silicon oil] in the fuser unit. This error shows when the oil is used up or has lesser quantity. The error will be reset after the oil is refilled. But I highly recommend an experience tech to do this, otherwise you may damage machine/components.
The machine has no fuser oil. Fill the little tank at the back side of
the machine. If the tank is full, check the tubes, oil pump, and oil
sensor.
Reboot the machine to clear the SC.
The problem will be solved
The Auto Code Scan feature allows you to set up your components without having to enter in code numbers. The Jensen will do the work for you! (It may take a few minutes to find your code using this method.)
Turn on the component that you want to set up.
Hold the component key down until the light comes on. The green light should come on after approximately 3 seconds.
Release the component key.
If you are programming the DVD or CD device press the "action" key. The red indicator light will come on.
Press "0" - "9" The green light will blink as codes are sent.
As soon as the remote turns your component off, press the "action" key. (You have 1 second in which to press the "action" key to save the code.) The component key lights will blink with an upward motion when a code has been successfully entered. The component is now programmed. To find that code, proceed to Code Readback.
If none of the codes turn your component off, return to step 2 and start over.
I have a suggestion , Stop posting complaints and until you find out how stop coming here and reading tese stupid ass comments that lead you no F**King where
how do you get to SP mode?
×