Canunit will not turn on

First, Turn off the unit. Thern, Rermove the pre-filter & gently clean with soap & water, rinse well. Finally, dry & replace back into unit. Then turn back on unit & the light should be off.

If you still need the manual I have a copy.

There's an Oreck repair center in Mishawaka, IN 46545. It's about 75mi from your location. There is a closer store called Wabash Appliance & Electric but without a website, you will have to call to see if they repair air purifier units.

Wabash Appliance & Electric 1105 N Cass Street
Wabash, IN 46992
(260) 563-0603

Oreck Clean Home Center
4215 Grape Rd.
Mishawaka, IN 46545
(574) 277-2800

Best of luck!
Greg

Hello,

if it does not power up, then it means its having a power problem. it might have worked fine in the past, but that's electronics for you. Power surge, irregular power supply, excess power supply, etc can affect the unit thereby not making it to power on.

This unit must have a power supply board in it where power enters from the mains. A capacitor, fuse, diode, etc may have been defective on the power board and maybe that's why its not making the unit turn on. There might also be some disconnection or something, inside the unit which is not making it to power on.

To actually find out what's wrong, you need to disassemble the unit with a screw driver and check what's wrong. You will be needing a meter in order to test the components on the power board, once you detect any bad component, you can make necessary replacement at any electronics accessories store withing our vicinity. This is the only way by which you can detect the problem.

Of course, testing the power board with a meter will require someone that has the ability. So it you can't, then you might be needing the help of a repairman or you can call a friend that has the ability to help you out.

I wish you the best of luck.

Regards.

Google Alpine Air Parts & Repair and you'll find several sites at the top of the list, that sell parts.

The plug in the back may have come loose that connects the buttons & lights to the circuit board. Have you ever taken the machine out of the wood carcass? You will need to do so to re-connect the plug.

Call tech support, they may have some ideas, it's free!

There is a fuse in where the AC cord plugs into the purifier. Remove the back cover, and you should be able to remove the fuse by prying the fuse cover off with at straight screwdriver. It takes a 1.6 amp fuse for 120Volts

I would recomend calling the 800 number to answer that question. I have this unit too and the instructions do NOT say to soak in Amonia and Vinegar! Good luck with that!