Zanussi ZEBF250W Bottom Freezer Refrigerator Logo

Question about Zanussi ZEBF250W Bottom Freezer Refrigerator

2 Answers

Fridge Door not shutting/sticking

Hello, The fridge door on our Zanussi Fridge/freezer has just stopped sticking altogether. I have cleaned the seal, and taken all the food out of the door and it still does not stick any longer - can you suggest a reason for this? The door is not damaged in any way and still sticks right etc. Thank-you for any suggestions.

Posted by Amy Haggis on

Ad

2 Answers

douglas smith

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,462 Answers

The fridge door stays shut only by strip magnets inside the door seal. cause is possibly that the hinges are out of line or the cabinet distorted. try levelling the fridge and tilt slightly backwards

Posted on Apr 03, 2007

Ad

Anonymous

Fridges should be placed level, not tilted. You can hold a small, light piece of iron against the seal to see if it stays put (meaning the seal is still magnetic). If not, it has become demagnetized. The vibrations of slamming the refrigerator door may induce the magnetic dipoles to randomize and thus lose magnetization. Heating or an electric current may also be the cause.

Posted on Aug 20, 2007

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My Neff fridge (K4316X1/GB) door does not close tightly on it's own and so does not seal properly unless I press it home

Try the following:
  1. Make sure there is nothing sticking out the fridge what could keep the door from shutting;
  2. Take a good look at the hinges and perhaps clean them or lubricate them (using Teflon spray);
  3. There is a white rubber strip all around containing the magnet with which the door should seal itself. Clean this rubber strip and the surface of the fridge it lands on;
  4. Make sure the fridge is level.
0helpful
1answer

Zanussi zenb9950si

What is the beep for ? Temperature sensor ? Power sensor ? Door open sensor ?
0helpful
1answer

Fridge is out of gas in fridge compartment. Freezer compartment is in order

if the freezer is operating ok,then the refrige side isnt out of gas,its the damper vent door between the freezer and refrige thats not opening to let cold air into fridge from freezer,sometimes they stick shut due to ice from condensation on this door,remove grille cover on damper door and check this,if iced up defrost it with a hair dryer,then change temp selector and make sure door then moves with temp change
0helpful
1answer

I have a zanussi fridge freezer model no zx56/4w. the fridge door was left open for 10 days now fridge is too warm and freezer is icing up

you need to totally defrost the fridge/freezer and start as if it were new and dry.allow 24 hours for the unit to settle to the correct temp.
please leave feed back
0helpful
1answer

I have a kenmore top freezer refrigerator model 253 about 1 1/2 years old. The fridge door sticks at the bottom of the door and the bottom of the fridge inside. There are scratches on the fridge bottom...

i had the problem my self :)
you need to take the freezer door out then the fridg door and add small ring like 1mm to the hinges of the fridg door poot all back and see if it rais the door a bit....
what i did is on the top of the freezer there is option to move the door from side to side ...the plastic that go into the freezer body its a ring with long tube.. i cut the tube and use that plastic :) good luck
4helpful
1answer

How to fit a Zanussi fridge door seal

You mean you have a door gasket. A good, step-by-step article on this pesky concept of "panel-screw" gasket installation is found on this handy page:

http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Appliance_Zone_Refrigerator_Install_A_Refrigerator_Door_Gasket.htm

This should help!
Brad
1helpful
1answer

Fridge freezer

  • Check the temperature setting
  • Assure that there is enough room for air flow in the refrigerator or freezer
  • Check for air flow restrictions in vents
  • Test the temperature control
  • Clean the condensor coils
  • Check the door seals
  • Test the door switch
  • Test defrost heater
  • Test defrost timer
  • Test evaporator fan
  • Check for a clogged drain tube
  • Check for refrigerant leak
0helpful
1answer

Door on Zanussi Fridge Freezer ZTX520w

what causes this is the cabinet has moved ( twited ) from not being leveled on first install. what we do is pack the hinge up with a washer.
Not finding what you are looking for?

3,469 views

Ask a Question

Usually answered in minutes!

Top Zanussi Refrigerators Experts

Brad Brown

Level 3 Expert

19101 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7312 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

49837 Answers

Are you a Zanussi Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...