Water in Fabric Conditioner Drawer

The detergent drawer should be removed and thoroughly cleaned - the drawer will open to the usual limit and then will withdraw completely with a little more force. The cavity the drawer fits into also should be cleaned along with the outlets that should now be easily visible.

Even after doing all that it is not unusual to find some water left behind in the drawer compartments. Sometimes it is necessary to remove the internal hoses and rod them out.

Fabric Softener Compartment Full Of Water - White Goods ...

www.whitegoodshelp.co.uk > ... > DIY Washing Machine Repair Help

Jul 9, 2013 - The small fabric conditioner compartment in the soap dispenser drawer has a plastic cap or tube at the back for the water to siphon up through. ... Make sure the washer is level front to back as well as side to side. .... If the washing machinehasn't been used since there's always the possibility that the plastic ...

The fabric softener part of my washing machine drawer keeps ...

www.mumsnet.com > Topics > Housekeeping

MumsnetAfter each wash, the fabric conditioner part of the drawer is f. ... The fabric softener part of my washing machine drawer keeps filling with water ... Stopped using thedispenser compartment for fab softener and instead did I separate ... see if that clears it up and also try cleaning behind the drawer in case there is a blockage.

Washing Machine ' Fabric Softener ' Problem ' Won't Empty

Fabric Softener Compartment Full Of Water - White Goods ...

www.whitegoodshelp.co.uk > ... > DIY Washing Machine Repair Help

Jul 9, 2013 - The small fabric conditioner compartment in the soap dispenser drawer has a ... filter at the bottom of my machine is also full of water after every wash my machine is Russell ... My washer flushes out the softener but then leaves the water at the end. ... When the wash cycle has finished the fabric conditioner ...

Check that the hose that connects the drawer to the tub is clean, fabric conditioner normally gunks up especially on colder wash cycles.

fabric conditioner drawer is always full of water This video will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.

Hello,
I dont know what model you have but you are correct in your assumption that the conditioner is siphoned out on the last rinse unless it is different for your model.Most machines I am familiar with operate in the first instance.Check that you have good water pressure to all compartments also get a toothbrush and clean the holes above the drawer even a bent piece of wire to unblock the small holes.

Good luck

Take out the drawer and clean the compartment and pipe at the end of the drawer with hot soapy water - washing up liquid works well. Clean all around it. Use a pipe cleaner, cotton buds or piece of coiled curtain wire to ensure that the U shaped pipe is clear of obstruction. Pull it back and forward to dislodge any accumulated fabric conditioner. To show this is working OK, put it in the sink and fill up the compartment with water until it is overflowing then stop. The water should drain out of the compartment on its own.

Next, where the drawer fits in the machine clean the water exit above the drawer with a washing up brush. This can appear brown or white depending on your water type. If this is OK try running the machine. If there is still a problem, remove the drawer again and turn off the power at the mains. Use something like a paper clip to poke all the holes in the water dispenser area above the drawer. There are lots of them so some patience might be required. If you live in a hard water area it could be blocked with limescale in which case an application of a descaling mousse or spraty will assist. Once complete, make sure you rinse the drawer area, drawer and put the drawer back in and run the machine on a short cold fill wash cycle. Put some fab con in the drawer to test that the machine drains it correctly. A good idea is to slightly water down fab con concentrate as it will eventually clog up the dispenser. If all is well then there will be no fab con left. If it is still there then you will need to get into the water dispensing area to see what is wrong. Occasionally the mechanism can get jammed, lose a spring or just get broken, in which case it will need replacing.

Pull the drawer out as far as it will come and then grasping it firmly, give it a good tug towards you, this will free the drawer to enable you to thoroughly clean every piece of it, particularly the conditioner parts of it.
Get a piece of wire with a bend on the end, and poke it in to all the holes in the top of the dispenser compartment, this will clera any blockages there.
Plz rate my solution, and feel free to leave any comment.
Thanks.

normally pull back and than lift. It sdould be mantioned in your manual under CLEANING.