Question about Honda 25cc 4-cycle Mini Tiller

1 Answer

The tillers start working and right away stops, the tiller still runs just the tillers don't

Mini-Tiller FG100 when the tiller is running, the tillers start, but them stops so it will run but not till.

Posted by mary grist on

Ad

1 Answer

mike butler

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,468 Answers

Check the shear pins on the tine shafts

Posted on Aug 07, 2012

Ad

2 Related Answers

kel1guy2002

Kelly

  • 3740 Answers

SOURCE: My Honda fg100 tiller started

Pull off the float bowl. Clean the bowl and bowl nut. Also in the threaded are where the bowl nut screws in there is a fuel jet / orifice with a tiny pin hole in it. If you have a inlMake sure that pin hole is clear of debris. Pull off the hose going to the carb and make sure you have good fuel flow to the fuel manifold. If you have poor fuel flow check the in line filter and the fuel tank exit port for debris. Use carb cleaner to clean fuel passages. With the float bowl remove the the main fuel line disconnected shoot carb cleaner from the float needle to the fuel hose connection and then from the fuel hose connection to the float needle. Reinstall the main fuel hose, float bowl and nut. Check for leaks BEFORE switching on the ignition.

Additionally make sure the engine Oil is serviced correctly. There is a low oil sensor that will kill the ignition if the oil level is low. For trouble shooting only you can disconnect ONE wire and check spark. If you did not have spark with the oil sensor connected and you have spark with it disconnected then the oil level sensor is either working correctly sensing a low oil lovel or... it is dirty and needs cleaned.

This SHOULD get you up and running again. If not just respond here with your ENGINE number and I will help you

Thanks for choosing FixYa,
Kelly

Posted on Apr 07, 2011

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The tiller starts and runs well for about 10 to 15 minutes but then will bog down and stop running . It will restart and run for about 30 seconds and then stop again. Any ideas about what is causing this,...


It sounds like a carburetor fuel issue. Which you could try attempting to adjust the carburetor (or have someone else do such) to see if that cures the problem.

May 16, 2014 | Honda 25cc 4-cycle Mini Tiller

2 Answers

Honda mini tiller cuts off when start tilling. runs great when held above ground with no load. cut off seems to be associated with the movement and shacking when tilling ground.


Hi thermo259, sounds like the high speed adjustment is lean, find the high speed screw and turn it counter clockwise 1 half turn and see if that helps. Should cure it.

Dec 10, 2010 | Honda 25cc 4-cycle Mini Tiller

1 Answer

Tines run slow/stop even when engine is at full throttle


What is the task you are doing with the tiller? There are some uses where the tiller will stop.

Jun 16, 2010 | Honda 25cc 4-cycle Mini Tiller

1 Answer

Tiller runs at idle but will not accelerate


Clutch or transmission, a common problem with the fg100 series

Apr 10, 2010 | Honda Hmantis Mantis Garden Tiller with...

2 Answers

What type fuel; and mixture for honda fg 100 mini tiller


the Honda FG100 is a 4-cycle engine do NOT mix oil with the gas, - you will cause damage to the engine (head, valves, piston rings etc) not to mention if will not run well.

Mar 08, 2010 | Honda 25cc 4-cycle Mini Tiller

2 Answers

I need a worm wheel for a Honda minitiller FG100.


You can buy parts for this from www.petessmallengine.com
I had to replace the tine shaft w/worm wheel assy. This is usually the weak point in the transmission. The worm is made out of brass.

Jan 03, 2010 | Honda 25cc 4-cycle Mini Tiller

1 Answer

My tiller starts and runs it also turns the tillers but when I try to till the tillers stop. It is a MTD


sounds like a belt or clutch problem. you didnt give enough info to look up the tiller.

Jul 06, 2009 | Mtd Garden

Not finding what you are looking for?
Honda 25cc 4-cycle Mini Tiller Logo

Related Topics:

1,670 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Garden Experts

John Trevino

Level 3 Expert

1420 Answers

JOHN LAPIER

Level 3 Expert

2601 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Honda Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...