Question about LG WM2277H Front Load Washer

1 Answer

LG Tromm WM2277 leaking from back bottom

During the wash cycle it is fine, rinse cycle is fine...when it gets to the last spin cycle it leaks water out...

Posted by kgonzalez99 on

Ad

1 Answer

Poppa Maddo

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 372 Answers

The last spin is the final Emptying phase. There has to be a leak somewhere in the exiting water route. All tubing and the water pump along with all clamps will need to be checked for integrity.

Poppa

http://www.cdbaby.com/cd/poppamadison

Posted on Oct 03, 2013

Ad

5 Related Answers

Anonymous

  • 2 Answers

SOURCE: lg washing machine wft855a top loader

Following up my comment from yesterday, I took the machine apart and discovered that the black rubber cover on the valve that releases the cold water had perished and cracked, and wasn't opening properly.
I tested the hot and cold solenoids and everything checked out ok. Was just the cold valve sticking.
The wash cycle was working because I was using hot/warm water. As the rinse cycle needs cold water to get started, it was not working and the rinse and spin cycles wouldn't complete.
I have swapped the valves over for now (put the working hot one on the cold side and am using cold water only). It's working while I order a replacement...

Posted on Dec 10, 2007

Ad

Anonymous

  • 10 Answers

SOURCE: Tromm Washer Model # WM2277HW by LG

will it spin after it washes if it does not then your belt might be broke

Posted on Feb 12, 2008

johnychel

isaac johny

  • 796 Answers

SOURCE: spinning cycle

Keeping in mind that the soap & bleach gets dispensed into your wash on the second to last rinse cycle and that most all rinse cycles are in cold water. Is your cold water valve screen plugged causing your washer to rinse poorly? Are you using the HE detergent? If not maybe the washer is sudsing up to much and having a hard time rinsing all the suds and bleach out and leaving the clothes soapy.

Fill the washer up with no clothes in it on a cold/cold wash setting does it take a long time to fill the washer up? Also when it is full and agitating is there suds in the washer?

Last suggestion is if the drain is hose is a lot higher than the top of the washer it might have a hard time draining out all of the soap water before the next load

Posted on Mar 23, 2008

Anonymous

  • 187 Answers

SOURCE: Front bottom leak from my LG TROMM HE Washer

  • Hi
  • Try these:
  1. Inspect the water supply connections
  2. Inspect the drain hose
  3. Inspect the water pump
  4. Inspect outer tub for cracks or corrosion
  5. Inspect the tub seal
  6. Inspect the tub bearing
please rate my suggestion...

Posted on May 22, 2009

steelskyway

  • 22 Answers

SOURCE: Error Message and Tub not spinning

Depending on how many clothes are in the washer you may a unbalance error

Posted on Jul 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Washer is leaking during rinse/spin cycle


What is the model number of your unit?

Nov 23, 2012 | Washing Machines

1 Answer

Washing machine leaks during spin and drain cycle


If the leak is still present after you replace the hoses , you may need to get a new water pump ( cheap part ) it is probably leaking , it removes the dirty water from the washer during spin and rinse cycle . hope this helps

Jun 28, 2012 | Washing Machines

1 Answer

Not getting enough water during rinse cycle


In the rinse cycle it will use cold only to rinse with.
You need to see how fast the water is going into the machine on rinse
Things that can effect slow fill, low water pressure, Faulty cold valve
water hose & valve filters clogged, Kinked hose

Feb 21, 2012 | Fisher and Paykel IWL12 Top Load Washer

1 Answer

The water runs during the spin cycle. The clothes


Does the water run through the ENTIRE spin cycle? There is a period where the water will run during the spin; This is called, the "Final Rinse". But it usually only runs for about 10 seconds then stops.

Dec 22, 2009 | Washing Machines

1 Answer

Kenmore washer series 80, Clothes still soapy


If you are getting no water spray during the rinse cycle that would cause the soapy clothes issue.

Are you getting cold water during the wash/rinse cycles? If you have the machine set to warm/warm you may only be getting hot water while the final spin is calling for cold.

If you have cold water available then the timer is not calling for the water spray. The problem is either in the mixing valve or the timer.

Jan 10, 2009 | Kenmore 23822 Top Load Washer

1 Answer

Basin will not fill with water during rinse cycle but will agitate and spin.


most new washers have cold water only rinse and spray rinse ck cold water coming into machine during wash if no cold comes in suspect cold side of fill vale not opening ..could be wiring issue or a bad valve

Oct 24, 2008 | Whirlpool Ultimate Care II LSQ9564J Top...

1 Answer

Tube doesn't spin during rinse/spin cycle.


It needs a new clutch. Call a repair technician.

Nov 19, 2017 | Washing Machines

1 Answer

Washer does nothing during rinse then leaks during spin cycle


hi thanks for the question i would check the drain hose your problem is the washer is not draining check the drain hose thanks the appliance doc

Sep 27, 2008 | Maytag Atlantis MAV6000 Top Load Washer

1 Answer

Leaking


The pumps usually have rubber hoses fitted them and they can deteriorate over time, moreso around the clamps that hold them onto the pump. Also, maybe the pump has been slightly opened via a worn seal. Either way, there may be a risk of fire if any water gets onto the electrical connections of the pump or spray onto any other open electrical connection inside the machine. It would certainly be advisable to have it checked with some urgency.

During the final rinse and spin, I would think the pump may not be used during these cycles.

Hope this helps somewhat.

Sep 14, 2008 | Whirlpool WTW6400SW Top Load Washer

Not finding what you are looking for?
LG WM2277H Front Load Washer Logo

372 people viewed this question

Ask a Question

Usually answered in minutes!

Top LG Washing Machines Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3053 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Cindy Wells

Level 3 Expert

6133 Answers

Are you a LG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...