In our office we cannot stay connected to the WAP54G via Wifi with cellphones. It shows you are connected but get no data.
SOURCE: WAP54G bricked power led blinking LAN connection shows as not connected
you did not specify where the wap is connected when you pinged it. Try this, connect the wap54g to your pc. Assign static ip 192.168.1.5 on the lan of the pc, then ping 192.168.1.245. if you can ping you should be able to access the configuration page. if the power is still blinking you can upgrade the firmware
SOURCE: can connect to internet through modem but not through wifi
If thats the case I will assume these things:
- You are seeing the wireless router when you are trying to connect but it still wont let you connect.
OR
- You are NOT seeing the wireless router and want to connect to it.
What you will have to do it go back into the router (hard wired into it) and start over. Make sure you access the wireless setting and ensure the settings are compatible with your wireless laptop. If your laptop is very new then the setting at the bottom will work if your laptop is older then the options like WEP/WAP Personal setting will do. Make sure you write down the settings you used for refrence later.
When you rename the device, wirite it down too!
Ensure you "Apply" all the settings and "Logout."
When you are done, go to "Start," "Control Panel," "Network and Sharing Center," "Set-up a connection or network," "Manually connect to a wireless network," and enter all the information you wrote down!
Let me know if there is anything else you need help with!
-paul
137 views
Usually answered in minutes!
×