Samsung HCN653W Transport

Not knowing what model you are referring to, this is what I can come up with.

Transport/Fusing Motor Error The LOCK signal error is detected when the EGB monitors the transport/fusing motor state. (This monitoring is done immediately after power-on, when the motor starts rotating, and immediately after the motor stops.)

• Disconnected or defective motor harness.
• Motor slips due to excessive load
  1. Check the harness from the transport/fusing motor. Replace it if necessary.

im not an expert but i own a transport and i have changed the battery it took about 30 min there is a brace to take off and a washer reservoir the rest is self explanatory.

A. Most modern drafting tables are made from steel because steel is really strong, but also portable. Old tables made from wood were really strong but difficult to transport or move around. To make the table even easier to transport, the surface is attached with screws that can be unscrewed.

There are some companies that sale outdoor chairs that have some pieces that are designed to collapse or come apart for easier storage and transport.

It does the machine has 2 sets of trays permanently attached all below that come off. The stapler comes off (if installed). The Document feeder can be removed. Do not lay it on it's side unless you take out the drum and developer units out I would avoid this if possible.

Micron PC : http://www.micron.com/

it is very difficult to replace the transport bolts, it's far easier to pack pillows or old blankets beside the drum from underneath.

LOOK where your speakers are , just in front there is a cover where your font keys are talk a small screwdriver pull cover off you will see two screws that it put out the keyboard the pull you cable , note reinstall just backward...good luck.....

1st remove the 2 screws on the back of the laptop marked keyboard then open the Lcd look at the keyboard down where the spacebar is there are 3 clips take a small stright screwdriver and push in the small clips in that will let the keyboard come free from the laptop unplug the keyboard ribbon and take out keyboard.

You weren't very specific about your problem, but assuming you've tried different inputs and tried messing with the convergence setting, it may indeed be the signal board, and you may need to have it replaced. BTW these sets also have an issue with the dynamic focus circuit and with crt fluid leakage. Make sure that you do not have a fluid on one of the crt boards. And as always with repairmen, a second opinion couldn't hurt.