Sounds like I may have a converge problem tried to run the majic focus and when it gets to the red, only 3 vertical bars lite up under the word majic focus and it stops right there and ends the majic focus test, any ideas, see white blue and red looks like 3D with out the glasses.
An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 500 times.
Re: hitachi 61swx10B digital rear project
Yes it certainly sounds like you have the old convergence outpuyt IC's that have gone bad in this TV set. If you have the soldering skills, and know how to work on printed circuit boards, you can repolace both of the STK convergence IC's. If you do not, you can get the complete convergence board at http://www.ptscorp.com, and the Hitachi board number is JT22056. Good Luck
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Yes,U know how to solders?Must replaced the 2 convergence ICS and all it resistors. Buy a convergence kit at Tv Repair World.com,Tvrepairkits.com.To repair it ur self. The shop will cost U $300 for parts and labors.
you need to replace both STK392-120 Convergence Ics. You can get replacement Ics at the following link and they provide free installation instructions so you can do the repair your self. Heres the link http://servicemanuals.vstore.ca/
To enter digital convergence adjustment
mode without removing the front speaker
grill, please do the following:
1) Press “Magic Focus” button on the front
2) While “Magic Focus” is running, press
Magic Focus button again to “Stop”.
3) Press “RECALL” or “STATUS” button after
“STOP” OSD appears on the screen to
enter digital convergence mode.
4) Proceed with convergence adjustment
and save the data.
5) Do MAGICS FOCUS sensor initialization.
6) To exit, press POWER button on the front
7) Normal and through 1080i modes are
stored separately. Each one has it’s own