By using the
Duplex button on your machine, you can set the machine to
print copies on both sides of paper.
1 Press
Duplex.
2 Load originals face up in the ADF.
3 Press the
Scroll buttons until the binding option you want appears.
•
Off: Prints in Normal mode.
•
1->2Side Short: Prints pages to be read by flipping like a note
pad.
•
1->2Side Long: Prints pages to be read like a book.
•
2->1Side: Scans both sides of the original and prints each of them
on separate two papers. (SCX-6322DN only)
•
2->2Side: Scans both sides of the original and prints them on both
sides of a paper, this function produce exactly the same print out
from the original. (SCX-6322DN only)
•
2->1Side Rotate2: Scans both sides of the original and prints one
of them on separate two papers, but the information on back side
of the original is printed 180° rotated. (SCX-6322DN only)
4 Press
OK to save your selection.
If the mode is enabled, the
Duplex button is backlit.
Collation
You can set the machine to sort the copy job. For
example, if you make 2 copies of a 3 page original,
one complete 3 page document will print followed by a
second complete document.
1 Press
Copy.
2 Load originals face up into the ADF.
For details about loading an original, see
page 5.1.
3 Enter the number of copies using the number
keypad.
4 Press
Menu until
Copy Feature appears on the
bottom line of the display and press
OK.
5 Press
OK when
Copy Collation appears.
6 Press the
Scroll buttons to select
Yes.
7 Press
OK or
Start to begin copying.
One complete document will print
http://www.websitetoolbox.com/mb/copierquestions
Thanks for the response. As I said, this problem is specific to Quark and seemed to appear out of nowhere. However, I have solved the problem by reinstalling Quark v.6.0. Problem arises upon installing the 6.2 upgrade. Tells me that there must be a conflict somewhere with the upgrade software. Decided to just go with v. 6.0. Can't run v.7 on my G4 Mac. Again, thanks for your interest.
I assume you have the Collate box clicked in the print set-up, yes?
Hmmm, Quark 5 was Pre-OSX, or OS9. Are other applications with OSX collating properly? It could be a driver problem, or specifically Quark. Have you tried a version of 7? Quark, or Quack 6.5 is problematic at best... I will run a test when I get to work tomorrow and see if it is app specific.
×