Recently replaced the black ink cartridge and now printer will not print an entire page. Starts out black then fades and becomes streaky as the pages finishes

It sounds like the printhead needs to be replaced. Brother may cover the cost of repair if you call them at 877-276-8437 and tell them the prints are "missing black ink". Very common problem that a new printhead should fix.

HI since you tried replacing the cartridges and cleaning the printhead, try the steps below.

1.Print a Demo Page.

a.Press the Menu button of the printer.
b.Use the down arrow key and select Print Demo Sheet.
c.Press OK button.

If demo page doesnt have black ink or faded prints,the printhead on your printer require replacement. Call 1.800.421.6699

Thanks.

Regards,

Neerak21

if your problem is printer setup page in go
and select to the b & w print and ink setting
are dark print set and give your print page
problem is also

toss it off the roof

You probably running out of black ink. Try replacing with new black ink cartridge.

Try to run a test print.

Hi,
At most cases of printer, especially which have done refill at cartridge, print quality is poor or streaky. Many factors influencing this printed result. To overcome print quality is poor, maybe following tips can usefull to prevent printed pages are missing lines or streaky.

First step is ordinary to be done many people when print quality is streaky that is doing cleaning. To get good printed result, sometime this facility is used more than once.
Use Ink Refill with Quality Nicely
For printer have refilled, sometime the quality of printing is also influenced by ink. If will fill your printer again, use ink which the was quality of nicely. I have tested some refill inks at cartridge which have been ascertained still nicely ( sorry: I do not want to publicize result of this attempt). In the reality result make me surprise, there ink of refill making the printed quality is crummy. To choose ink refill read following tips :

• See viscosity of ink, every merk of ink refill have difference of viscosity. Don’t use Ink refill too jell. Difference of this viscosity is no measure reference viscosity of ink from factory maker of printer
• Don’t fear to try some inking merks. Done this, you’d find refill ink fitt with your printer. I now only using one merk of refill ink ?.
• This suggestion of forum, but I still not yet proved. May believe or not. Good ink aroma of soft usually.

Change Original Cartridge
This is last choice. A lot not like to do this ways, because price of original cartridge still costly. Alternative, you can use compatible cartridge which the was price of cheaper than original cartridge. At newest printer, usually there are two until four cartridge in one printer. And price four same cartridge almost at the price of printer even there are some costlier.

Let me know !

Thanks

Fame !

It's dried up inside of the cart.

model of the printer ? sound like a
heating device problem.

The print heads don't appreciate being out of ink so the Brother printer has sensors to prevent that but the tape defeated that prevention. Maybe more cleanings or maybe a cartridge with printhead cleaning solution will help. Otherwise, I fear a new printer.

Fiend your solution direct from hp. Here is your solution....

http://www.intel.com/motherboard/prob676ijt65/solution
824