Question about Pride Mobility Products Health & Beauty

1 Answer

Jet 2hd blinking 1 red light and will not move

Posted by larry smalll on

Ad

1 Answer

jane opery

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Check your drive leaver either on back or on the side of cart by the drive wheels some times it will come out of drive

Posted on Jul 22, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

JET 3 ULTRA. WHAT SHOULD THE LIGHTS LOOK LIKE WHEN YOU TURN IT ON? THE CONTROLLER SHOWS ONE RED LIGHT IN THE LEFT HAND CORNER BLINKLING. YELLOW DOWN BELOW FOR SPEED CONTROL.


All the battery lights should be on and the yellow speed control should not be blinking. a flashing red indicates charging is needed. Strege Mobility

I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

Oct 28, 2016 | Jet Health & Beauty

2 Answers

Why would my lights all be blinking on my Jet 3


Hello Cathy,there are many short videos to choose from on YouTube.Maybe,type in search bar:Binking lights fault on Jet 3.I hope this helped you

Jan 24, 2015 | Jet Health & Beauty

1 Answer

How to reset manual brake control and where is it.lights go on( 2 red & 2 green) but jet joy stick is so touchy lights blink and I have to restart it.


If the joystick turns completely off when you try to drive it means the batteries instantly are dropping voltage below the operating capabilities. I have also seen bad connections in the battery wiring harness cause the same thing.

Sep 15, 2014 | Pride Mobility Products New Pride Mobility...

1 Answer

It shuts off and blinks 11


AHX18MEV
4 - 12
[8] SELF-DIAGNOSIS FUNCTION
1. Indoor unit
(AH-X18MEV, AH-X18MEV-1, AH-X24MEV, AH-X24MEV-1)
To display the self-diagnosis, hold down the AUX button for over 5 seconds on the indoor unit when the indoor unit is not operating.
• The operation lamp (red), timer lamp (orange) and Super jet lamp lighter) flash to indicate the information of malfunction.
(Display of self-diagnosis result)
The operation lamp (red) and the Super jet lamp (green) flash in synchronization with the timer lamp (orange).
(AH-XP18MV, AH-XP18MV-1, AH-XP24MV, AH-XP24MV-1)
To display the self-diagnosis, hold down the AUX button for over 5 seconds on the indoor unit when the indoor unit is not operating.
• The POWER CONSUMPTION indicator indicates the information of malfunction by showing the main category error (number) and the sub-category
error (-number) alternately in 1-second intervals.
Example: Compressor high-temperature error
Remark

3. CHART
<INDOOR UNIT> ?:1-second ON / 1-second OFF
Problem
symptom
Outdoor
unit indication
(LED1)
Indoor unit Malfunction
No.
Content of diagnosis Check point Action
Lamp Main Sub Main Sub
Normal
condition
Normal
blinking
? ? ? ? ? Timer (Orange) 0 0 Normal
Operation (Red)
Super Jet (Green)
Indoor and
outdoor
units do not
operate.
1-time ? ? ? ? ? Timer (Orange) 1 0 Outdoor unit
thermistor
short-circuit
Heat exchanger
thermistor short
circuit error
(1) Measure the resistance
of the outdoor
unit
thermistors.
(1) Replace the outdoor
unit thermistor
assembly.
? Operation (Red)
Super Jet (Green)
? ? ? ? ? Timer (Orange) 1 Outdoor temperature
thermistor
short circuit error
(2) Check the lead wire
of the outdoor unit
thermistor for torn
sheath and shortcircuit.
(2) Replace the outdoor
unit thermistor
assembly.
? Operation (Red)
? Super Jet (Green)
? ? ? ? ? Timer (Orange) 2 Suction thermistor
short circuit
error
(3) No abnormality
found in above
inspections (1) and
(2).
(3) Replace the outdoor
unit control
PWB assembly.
? Operation (Red)
? Super Jet (Green)
? ? ? ? ? Timer (Orange) 3 2-way valve
thermistor short
circuit error
? Operation (Red)
? ? Super Jet (Green)
LED1
AU-X24MV, AU-X24MEV
AU-X18MV, AU-X18MEV
LED1

May 27, 2012 | Sharp Heating & Cooling

1 Answer

My Jet 3 has new batteries and they fully charge. When I am outside of the house the chair just cuts off like you turned of a switch. Leave be a while and it runs again. when you push reset button after it...


Alvin you have a left motor problem and it could be a loose connection Check that the left motor connector is tight and that if you move it the lights blink then there is a problem with the wiring to the left motor. If Medicare paid for your chair then they will pay for 80% of the repair costs contact your provider to see if they will repair it or contact a repair service like Roadrunner Mobility @ 1-800-467-2668 Hope this helps

Mar 01, 2011 | Pride Used Mobility Jet 3 Power Wheel...

1 Answer

Red light on my jet 7 keeps blinking and chair barely moves.


Sound like the batteries are on their last leg. Have them load tested.

Jul 17, 2009 | Jet 3 Ultra Power Chair

1 Answer

The charge lights blink and the chair won,t go.


Just had this problem with my Guardian Aspire. They had to replace the electronic box with the joy stick. BIG BUCKS!

Mar 12, 2009 | Jet Health & Beauty

Not finding what you are looking for?
Health & Beauty Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pride Mobility Products Health & Beauty Experts

Rob Hill
Rob Hill

Level 3 Expert

1414 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeff Bird

Level 3 Expert

1346 Answers

Are you a Pride Mobility Products Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...