Bluetooth Hi Toti, basically i bought my t10, it went faulty so i sent it back then they gave me a replacement. when the replacement came the bluetooth menu wasn't on it, i could connect to a phone or file transfer.... Any advice on what to the best way is to send it back but i want to know what your advise is frst please! Thankyou very much Sanj94

Hi Matthew,

With those headsets that think is a known issue.
If nothing happens when you hold down the answer button then the battery must be out (or the headset is faulty).
If you tried to plug it into a USB on a PC to charge it, and the red light does not stay on then I'm afraid it became faulty.
All you can do now is to get back to the retailer who sold it to you and get a replacement for it, or if the retailer cannot help you consider getting back to MadCatz requesting a replacement if it's still within warranty.

Hope it helps.

Go to manualsonline.com. They have a manual for the Technocel T10.

Hi,
This now the third time the problem has arose and you have had it in for repair twice. This indicates that the model range is suffering a generic problem as others are suffering from the same symptoms as you.
Now i don't know what your specific problem is but its usually a faulty graphics chip or card.
I think by now its time that Gateway gave in and gave you a newer model laptop because of the problems its suffering but that going to take a little determination from you, basically moan at them and refuse to give in.
Post back if you need anymore advice.


Good luck.

on the back...push th reset button...easy..

Yeah, they were quite well together i have them both.
To connect

1. Hold the switch button on the Free pulse until it flashes
RED & BLUE

2. Go to bluetooth setting in the T10 and add Headphones

3. Turn on headphones when turning on T10 should automaticaly connect.

- You have to set the Mac Address value after exchange PCB Assy.
(only Bluetooth product)

1. Disassemble the YP-T10 case and Find the MAC Address. (12 digit)
2. Open “memo pad” and write Mac Address on it.
3. Save “BDADDR”
4. Connecting USB, Copy “BDADDR” into Root.
5. To confirm Bluetooth Mac Address
- Power on
- “Setting – My Device Info – View the MAC Address”
6. If an error occurs, the address of the error is saved in
the ErrorMac .txt file as text
7. Mac Address Setting is done.

try do firmware upgrade.that one is for bluetooth

did u convert it on too the Samsung Media Studio or Emodio

yp-t10

In the Bluetooth Settings menu, go to "Stereo Headset" option, and see if you have any luck - make sure the headphones are connected to the Samsung, since the Samsung uses the headphones as antenna to get any kind of station reception.