What is the weight of CHAIN DRIVE 24 OL? - Franklin Machine Products CHAIN, DRIVE 24 OL - Sells As: 1 Each

OL errors usually mean that the washer is overloaded or the motor is working too hard to move the tub relative to the drive shaft during agitation of the load. For an overloaded washer, removing some items can help. However, if the bearings have failed or the shaft is corroded, then the hardware needs to be replaced. One way to check: run the washer with the tub empty. Do not add any detergent. If the OL error persists, then you have to identify the specifics of the hardware fault. A parts list for the WTW7300XW0 is here: https://www.partselect.com/Models/WTW7300XW0/ . There is a tutorial for replacing the parts on some Whirlpool washers here: http://techanswerslive.com/troubleshooting/kenmore-elite-oasis-washer-f51-error-code-explained/ . Whirlpool manufactured this model for the Kenmore label.

If your washer is older than you may want to consider replacing it. If it is covered by the original warranty, contact Whirlpool for a service call. I hope this helps.

Cindy Wells

ck.the oiler drive gear behind the chain sproket

what is the noise like

The FMP chain drive (51 links) costs $11. You can purchase it on this website: http://www.ablekitchen.com/supplies/FMP-189-1042/CHAIN-DRIVE-51-LINKS.html

The FMP chain drive (55 links) costs $12.19. You can purchase it on this website: http://www.lionsdeal.com/fmp-189-1025.html

The CHAIN DRIVE 24 OL costs $24.22 and can be purchased on http://www.twinsupply.com/equipmentparts/proddetail.asp?prod=183-1060.

The CHAIN DRIVE 24 OL is used on Vertical Conveyor Toaster models VCT30BK and VCT700BK.

oL Overloaded.
"oL" flashes when you got too dang many clothes in there. 18 pounds dry weight per load is what I go by. If the load is fine you could have an item of clothing in between tubs not allowing basket to engage.

Service Manual and codes HERE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

OL, usually means Over Loaded. It is an error code thrown up by the on board computer.. generally when TOO much wet weight is in the bowl.

TIMING BELT SHOULD BE 60,000 MILE CHANGE