Kenwood KDC-215S When I put a disc in it makes like a clicking noise and then its spits it back out.

Hope this helps:)

Step 1:

Press and HOLD the A.ADJ (Audio Adjust) button for 1 sec. to enter audio control mode.

Step 2:

Press either FM (or AM) button to select the mode you wish to adjust. Keep pressing until you find the mode you require (in this case, it will be BL for Balance).

To change the value, press the Down Search or Up Search button to your desired setting. Centre balance is "0", negative number is Left speaker, Positive number is Right speaker.

Step 3:

Repeat Step 2 to select the TREBLE (TRE) mode, then use Down, or Up keys to change the value.


Hope this helps.

Cheers,

Scott

You could add a switch to control the power going to the head unit. I have seen this done in many different vehicles where the head unit drains the battery, even when supposedly off.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Hi,

You can download the complete instruction manual in PDF format by clicking this link.

• You'll require Adobe PDF Reader installed on your computer to view the manual. If it is not already installed on your computer, download it free from: http://get.adobe.com/reader/

Thanks for using FixYa.

probably not

Some decks only give one pair of pre outs. Most 4 channel amps can use just a 2 channel input and feed the other 2 channels by the flip of an input selection switch. I recomend a 4 channel amp if you want to power front and rear speakers and be able to set the gains to blend properly, or you can run all 4 speakers at a 2 ohm stereo on 2 channels and run a sub on the remaining r channels. It just depends on how you want the setup to be nd to how much control you want. Let me know.

Larry T
Winona Lake, IN
http://www.cybersoundsaudio.com/cybersounds/vehiclepics.html

Reset the unit ithe reset button is on the cd changer

its the face plate just need to take out clean with little rubbing alcohol these kinda face plates has a scrolling feature that i donot like very much face plate just needs to adjusted back on sterio mount

you might need to up grade for the color change seeing that your saying its an old model

Contact a stereo shop. they should be able to get you an adapter that will interface it with the amp.