Have no wires for a Fusion EN-AT110 Basstube!!!

Do the diagnostics on the fault code first. You have the Ford emissions system Troubleshooting repair manual correct? If not try eBay for that and a wiring diagram booklet called the Ford Vacuum and Electrical Troubleshooting guide.

I just checked the specs and it supports Windows Server 2003 so it must be possible. They probably did not make a setup wizard for it so you will have to do it the "old fashioned" way. Load the Windows Server 2003 disk in the CD/DVD drive and boot to it as you would any Windows install. If it reaches the screen where it displays the hard disk(s) you are good to go. While the installation is running go to Acer's website on another computer and download the 2003 drivers to a USB drive. When the installation completes, install the 2003 drivers and you are ready to customize it to your needs.
If it doesn't find the hard disks, you probably purchased the optional PCIe 4-port SAS RAID card and Windows 2003 doesn't have a built-in driver for it. You will need to press F6 after Windows install starts so it will prompt you later for a driver for your disk controller. This will allow you to manually install the driver which you should be able to find on Acer's website. (F6 Info: http://en.wikipedia.org/wiki/F6_disk)
I hope this helps!

what is your problem with the 300 watt fusion basstube

Check the connection to the speaker first if not that then, check the connection to the head unit, inspecting the wire also, make sure both negatives and positives are aligned, if its none of the above might have a bad output on the deck or the speaker can be a dud.

brown yellow and green

Hello,

This is a rather common problem. The red light indicates it is not correctly getting power.

So trace your power wire from the battery--> check the fuse on the wire if there is one---> to your amp. If that is all in working order next move onto the ground wire.

Make sure it is sparking on the surface that you have it grounded at. If it does not spark when you touch the ground wire against that surface then you are not correctly grounded. It should be bare metal, something connected to the cars frame.

Try this and post back if you still need additional help. Thank you for choosing Fixya!

The amplifier is in protection mode.
3 reasons for this...

1. Improper Load/overheat - wrong impedence voicecoils or wired improperly below rated impedence.
2. Grounded Power - speaker wires touching, power wire touching ground,
3. Internal component failure.

if the amplifier will still not go out of protect mode after removing the speakers and jumpering the remote wire to the + terminal - your amplifier needs professional repair.

Thanks for using FixYa - a good rating is appreciated for taking the time to answer your FREE question.

Hi sean.
I've got the same problem as you, but if you follow this link you can download the manuals.......

http://www.fusioncaraudio.com/united-kingdom/en-language/type-car-audio/product-manual-list.aspx

you might have to paste it into your address-bar.

Swing..

WHAT U WANT TO DO IS GO TO A LIKE BESTBUY OR CIRCUIT CITY, AND ASK THEM FORM A RCA CONVERTER, THEM SHOULD HAVE WHAT YOUR LOOKING FOR, THEY CAN ALSO RUN ANYWHERE FROM $10-20.

Try a different speaker if there is no sound then it is your amp output fried. Goodluck.