Problem with D-link airplus wireless network card for my desktop

This happens when the wireless network card fails to get an IP address from the wireless router.
To get the router to issue your wireless network card with a new IP address, right click on the wireless card icon on the task bar and click Repair.

To connect to your wireless router, it needs the router's wireless settings configured and also the wireless cards in all the laptops and or computers needs to be configured with the router's wireless settings. Then the laptops and desktop computers can communicate with your wireless router.

To secure your wireless network from unauthorized access,please click on this link and follow my instructions :-http://www.fixya.com/support/r3559128-wireless_router_security

1. after power on you can connect your device to laptop or desktop through ehernet cable or wireless mode.

2. set your network adapter on automatic IP reconize mode and after get IP address you can configure your wireless device with 192.168.1.1 Ip address.

you can buy a usb wify adapter at wally world also knpwn as walmart. just plug it in and run disk and your connected

go to this link thanks please rate the answer
Here is the link

The card could be bad. I've found over the years that most of these desktop wireless cards work best when the software is installed before the card is installed. Meaning uninstall all the software. Turn off the machine. Remove the wireless card. Turn back on the machine. Install the software. Once installed, shut down the machine. Install the card. Turn back on the machine and lets Windows find the card and the software.

can please check if ur wireless card driver comes with a utility for wireless management, if so, try to connect using this utility.

i have D-link airplus G DWL-G630 wireless G notebook adapter i need driver wear i can get

are you sure you got the right drivers?

http://support.dlink.com/downloads/

Use that webpage to find the newest drivers for your card.

You have not mentioned having a wireless router or access point to serve as the hub on an infrastructure network. I you have a router please let me know -- the instructions for the solution changes.

The following is an article to create an ad hoc network between wireless cards without a wireless access point or a router. If you ignore the steps about connecting to the internet with a wired connection and the internet sharing instructions. This will allow your machines with wireless adapters to communicate with each other (assuming the operate on a common band). The article goes on to indicate one machine with a wired connection can act as the "router" for the other two when it is on to allow them share internet access with the wired machine (the wired machine also needs a wireless card for this to work).

Ad-hoc networking access point