MOVE LING FOR ADDS - Gateway Computers & Internet

How To Repair Washing Machine Stuck On One Cycle

so the throttle fails, in Park too? or neutral or in drive.
we need to know all facts here.
the throttle adds air the EFI measures that and adds fuel.
then RPM rises, to 3000 rpm easy in park.
does it do that?
then fail to make power in drive.? power is in move car?
check fuses first.
then scan it. using any scan tool works on all USA 1998 and canada. cars.

or "then it starts to go"

my guess now is ,that car drives ok, but has a small hesitation
and has full power up any hill wide open throttle and the transmission does not slip.?
is that it?
that can be a bad TPS sensor. (hesitates then catches up)

what is the delay time, from ignoring right foot to go.
1sec, 1 minute, what?

1. Since all of the settings seem to go through the start/stop button, hold it down for three seconds to put it in "set the watch mode" (when the seconds at the bottom start blinking).
2. Do a quick press of the start/stop button to move from seconds to minutes to hours to years to months to days. The mode button subtracts & the reset button adds.
3. Setting alarms & so on require putting it alarm mode via the mode button. Use the reset button to move to the selected alarm (1-5). 
4. Hold the start/stop button for three seconds to "set the alarm mode."
5. Quickly press the start/stop button to between things to set (kind of alarm, hours, minutes).
6. Again, the mode button subtracts & the reset button adds.
7. A three-second press of the start/stop button exits the setup mode.

sounds like the transmission is messed up

sounds like you might have malware installed. Install a free antivirus program and have it scan your computer. I use Avast

double posted and anony, how cute that is
but adds, DONT MOVE>
ok dont move in D,2,1, and R
why not tell the full story???? not just snippets, of facts.

ling ling

Two possible problems. Move the printer closer to the wireless router, and if that doesn't work, it is probably a failure in the printer. Also, see if there is a setting on your printer to force it to try to reconnect automatically.

All the settings seem to go through the start/stop button. If you hold it down for 3 (not 2, not 4, but 3) seconds, it toggles in and out of "set the watch mode". You can tell you are in it because the seconds at the bottom go all blinky. Use (quick press) start/stop to move from seconds, to minutes, to hours, to year, to month, to day. Mode subtracts, reset adds. To set alarms, etc, first put the watch into Alarm Mode (Mode button, again).
Use the reset button to move to the selected alarm (1-5).
Hold the start/stop button for 3 seconds to toggle into "set the alarm mode".
Quick press of start/stop moves between things to set (kind of alarm, hours, minutes).
Mode subtracts, reset adds.
3 second hold of start/stop takes you out of setting mode.

Happy Holidays Kkrew

How are you! well, for this particular problem, try to move the speakers away from magnetics fields, or microwaves.
happy day